Accessory Drive - Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
C | 1U-6396 | O 形圈组装固定胶 | 1 |
D | 4C-4030 | 螺纹锁固胶 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 检查前壳体 (3) 中的孔是否损坏。 如有必要,更换前壳体。 请参阅拆解和组装 , "壳体(前)- 拆卸"和拆解和组装 , "壳体(前)- 安装"。
- 使用工具 (C) 轻轻地润滑新的 O 形密封圈 (5) (未显示)。 将 O 形密封圈(未显示)安装到附件驱动壳体 ( 4) 的槽中。
- 轻轻地用清洁的发动机润滑油润滑所有轴承和所有的齿轮。 将附件驱动组件安装到前壳体上。 确保附件驱动壳体上的法兰与前壳体齐平。
- 将工具 (D) 涂敷到六角螺钉 ( 1) 和六角螺钉 (2)上。
- 将六角螺钉 (1) 和 ( 2) 安装到附件驱动壳体 ( 4) 上。
- 拧紧六角螺钉 (1) 至扭矩为
22 N·m (16 lb ft) 。拧紧六角螺钉 (2) 至扭矩为
44 N·m (32 lb ft) 。 依次拧紧图 2 所示的六角螺钉 ( 1) 和 (2)。 - 确保惰轮与附件驱动齿轮之间有足够齿隙。
Show/hide table
图 1 | g01441026 |
典型实例 |
Show/hide table
图 2 | g01444555 |
附件驱动的拧紧顺序 |
Caterpillar Information System:
C4.4 Industrial Engine Accessory Drive - Assemble
C4.4 Industrial Engine Accessory Drive - Disassemble
C4.4 Industrial Engine Accessory Drive - Remove
AP600D and BG600D Asphalt Pavers Machine Systems Drag Conveyor
2008/02/25 Correction to "Machine Repairs and Welding Procedures" {6107}
R1700G Load Haul Dump Machine Electrical System Indicator - Primary/Secondary Steering
AP600D and BG600D Asphalt Pavers Engine Oil and Filter - Change
AP600D and BG600D Asphalt Pavers Engine Oil Sample - Obtain
Installation of the Pitch and Roll Angle Sensor for CAESultra{1439, 7604} Installation of the Pitch and Roll Angle Sensor for CAESultra{1439, 7604}
Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467} Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467}
2008/02/04 A New Oil Level Gauge As and Oil Gauge Tube Assembly is Available {1326}
2008/02/11 Correction to Operation and Maintenance Manual , "Alternator Air Vent Line and Screen - Clean" {1071, 1405}
AP555E and BG555E Asphalt Pavers Machine Systems Feeder Drive Shaft (Drag)
C27 and C32 Engines for Caterpillar Built Machines Compression Brake Solenoid Circuit - Test
416E, 420E and 430E Backhoe Loaders Transmission (Autoshift) Transmission and Torque Converter - Test
AS2252C Asphalt Screed Flow Divider Valve - Remove and Install
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Remove
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Install
C27 and C32 Engines for Caterpillar Built Machines Switch Circuits - Test
854K Wheel Dozer and 992K Wheel Loader Power Train Electronic Control Module (ECM) - Flash Program
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
AP600D and BG600D Asphalt Pavers Fuel System - Prime
AP600D and BG600D Asphalt Pavers Fuel System Filter (Washdown) - Clean
AP600D and BG600D Asphalt Pavers Fuel System Primary Filter - Clean/Inspect/Replace