Accessory Drive - Assemble
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
B | 7M-7456 | 轴承安装固定胶 | 1 |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 检查齿轮 (7) 的轮齿和花键是否磨损或损坏。 拆下轴承 (6) 和轴承 (8)。 检查簧环 (9) 和前壳体 (4) 是否磨损或损坏。 更换任何损坏或磨损的部件。
- 在轴承 (6) 的内表面 (X) 处连续涂敷一小滴工具 (B)。 将齿轮轴放在适当的支架上。 按压轴承 (6) 的内表面直至轴承 (6) 抵到齿轮 (7) 的凸肩上。 清除所有多余的密封胶。
- 在轴承 (8) 的内表面 (Z) 处连续涂敷一小滴工具 (B)。 将轴承 (8) 内表面放在适当的支架上。 将齿轮 (7) 的轴按压至轴承 (8) 中直至齿轮的凸肩抵到轴承上。 清除所有多余的密封胶。
- 在轴承 (6) 和 (8) 的外表面 (Y) 处连续涂敷一小滴工具 (B)。 将附件驱动壳体 (4) 放在适当的支架上。 将齿轮组件按入附件驱动壳体中。 确保轴承 (6) 抵到附件驱动壳体 (4) 中的凹槽前面。 清除所有多余的密封胶。
- 将簧环 (9) 安装到附件驱动壳体 (4) 的槽中。 确保簧环 (9) 在槽中的位置正确。
Show/hide table
图 1 | g01440577 |
典型实例 |
Caterpillar Information System:
C4.4 Industrial Engine Accessory Drive - Disassemble
C4.4 Industrial Engine Accessory Drive - Remove
AP600D and BG600D Asphalt Pavers Machine Systems Drag Conveyor
2008/02/25 Correction to "Machine Repairs and Welding Procedures" {6107}
R1700G Load Haul Dump Machine Electrical System Indicator - Primary/Secondary Steering
AP600D and BG600D Asphalt Pavers Engine Oil and Filter - Change
AP600D and BG600D Asphalt Pavers Engine Oil Sample - Obtain
Installation of the Pitch and Roll Angle Sensor for CAESultra{1439, 7604} Installation of the Pitch and Roll Angle Sensor for CAESultra{1439, 7604}
Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467} Installation Instructions for the New Caterpillar Digital Voltage Regulator (CDVR) In Field Retrofit Applications{4467}
2008/02/04 A New Oil Level Gauge As and Oil Gauge Tube Assembly is Available {1326}
2008/02/11 Correction to Operation and Maintenance Manual , "Alternator Air Vent Line and Screen - Clean" {1071, 1405}
C4.4 Engines For Caterpillar Built Machines Engine Will Not Crank
C4.4 Industrial Engine Accessory Drive - Install
AP555E and BG555E Asphalt Pavers Machine Systems Feeder Drive Shaft (Drag)
C27 and C32 Engines for Caterpillar Built Machines Compression Brake Solenoid Circuit - Test
416E, 420E and 430E Backhoe Loaders Transmission (Autoshift) Transmission and Torque Converter - Test
AS2252C Asphalt Screed Flow Divider Valve - Remove and Install
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Remove
AS2252C Asphalt Screed Gear Motor (Vibratory - Main) - Install
C27 and C32 Engines for Caterpillar Built Machines Switch Circuits - Test
854K Wheel Dozer and 992K Wheel Loader Power Train Electronic Control Module (ECM) - Flash Program
Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091} Procedure to Handle and Ship Diesel Particulate Filters (DPF) and Catalytic Converter Mufflers (CCM){1091, 1091}
AP600D and BG600D Asphalt Pavers Fuel System - Prime
AP600D and BG600D Asphalt Pavers Fuel System Filter (Washdown) - Clean