Accumulator Charging Valve (Brake) - Install
Installation Procedure
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Install brake accumulator charging valve (1) and two bolts (6) .
Show/hide table
Illustration 1 | g01081947 |
- Connect adapter (5) .
- Connect hose assembly (4) .
- Connect hose assembly (3) (not shown) and hose assembly (2) .
Show/hide table
Illustration 2 | g01081946 |
- Purge the air from the braking system. Refer to Systems Operation, Testing and Adjusting, "Braking System Air - Purge".
- Test the brake accumulator charging valve. Refer to Systems Operation, Testing and Adjusting, "Accumulator Charging Valve (Brake) - Test and Adjust".
- Fill the hydraulic tank with oil to the correct level. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check".
End By: Separate the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Caterpillar Information System:
R2900G Load Haul Dump Machine Systems Accumulator Charging Valve (Brake) - Remove
CP-323C and CS-323C Paving Compactors Machine Systems Wheel and Tire - Remove and Install
988H Wheel Loader Machine Systems Evaporator Coil and Heater Coil - Install
CB-334E and CB-335E Vibratory Compactors Engine Supplement Engine - Install
446D Backhoe Loader Power Train Rear Axle - Install
CB-334E and CB-335E Vibratory Compactors Machine Systems Drive Shaft - Remove and Install
446D Backhoe Loader Engine Supplement Refrigerant Condenser - Remove and Install
446D Backhoe Loader Power Train Rear Axle - Remove
446D Backhoe Loader Engine Supplement Fuel Filter and Base - Remove and Install
988H Wheel Loader Machine Systems Evaporator Coil and Heater Coil - Remove
Installation Guide for the Machine Security System on Skid Steer Loaders and Multi Terrain Loaders{7631} Installation Guide for the Machine Security System on Skid Steer Loaders and Multi Terrain Loaders{7631}
446D Backhoe Loader Power Train Drive Shaft (Rear) - Remove and Install
2004/06/21 Special Instruction, REHS2149, "Explanation of Common Event Codes and Transmission Shift Matrix" is now Available {4800, 4808}
824H Wheel Dozer, 825H Soil Compactor and 826H Landfill Compactor Machine Systems Front Frame from Rear Frame - Separate
446D Backhoe Loader Power Train Tie Rod (Steering)(Front) - Remove and Install
2004/07/01 Engines Are Now Built with Semi-Crowned Lifter Rollers {1209}
446D Backhoe Loader Power Train Steering Cylinder (Front) - Remove and Install
2004/07/05 Improved Analysis of Non-Warrantable Failures for Reman Vane Cartridges {5055}
988H Wheel Loader Power Train Engagement Pressure for the Transmission Clutch (Operator Monitor) - Calibrate
446D Backhoe Loader Power Train Drive and Steering Axle (Front) - Remove
446D Backhoe Loader Power Train Drive and Steering Axle (Front) - Install
446D Backhoe Loader Engine Supplement Hydraulic Oil Cooler - Remove and Install
446D Backhoe Loader Power Train Final Drive (Drive and Steering Axle)(Front) - Remove
2004/08/02 New Proportional Control Handle Is Now Available {5705}