Removal Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 185-3630     | Strap Wrench As     | 1     |
ZZ     | 6V-9508     | Face Seal Plug     | 2     |
6V-9829 | Cap Assembly     | 2     |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolt (4) and the clip from the engine block.
Illustration 1 | g00629572 |
- Loosen clamp (2) and remove the hose from crankcase breather (3) .
- Remove bolt (1) and remove crankcase breather (3) from the fuel filter base.
- Use Tooling (A) to remove fuel filter (10) .
Illustration 2 | g01080329 |
Typical Example |
- Disconnect tube assemblies (5) and (7) from fuel filter base (9) .
- Remove O-ring seal (6) .
- Remove bolts (8) from fuel filter base (9) .
- Remove fuel filter base (9) and the gasket from the engine.
- Remove fuel pressure relief valve (11) from fuel filter base (9), if necessary.
Illustration 3 | g01080339 |
Installation Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 185-3630     | Strap Wrench As     | 1     |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install fuel pressure relief valve (11) on fuel filter base (9) .
Illustration 4 | g01080339 |
- Inspect the condition of the gasket. Replace the gasket, if necessary.
Illustration 5 | g01080329 |
- Position the gasket and fuel filter base (9) on the engine.
- Install bolts (8) that secure fuel filter base (9) on the engine.
- Connect tube assemblies (5) and (7) to fuel filter base (9) .
- Use Tooling (A) to install fuel filter (10) .
- Install O-ring seal (6) on fuel filter base (9) .
- Inspect the filter in crankcase breather (3). Replace the filter, if necessary.
Illustration 6 | g00629572 |
- Position crankcase breather (3) on the fuel filter base and install bolt (1). Tighten the bolt to a torque of 7 ± 2 N·m (62 ± 18 lb in).
- Install the hose on crankcase breather (3) and tighten clamp (2) .
- Install the clip and bolt (4) on the hose.