New Oil Drain Tube for the Turbocharger {1052, 1307}
- Engine: Commercial
- 3500 and 3500B Family All
- G3500 Family All
- Caterpillar Products:
- 3500 Family Generator Sets and Power Modules
- 3500 Family Pumpers
- G3500 Family Generator Sets and Power Modules
Description of Change: Improved oil drain tubes are used on 3500 Engines. The connecting end of the oil drain tube has a reduced outside diameter. This will reduce the potential for breakage due to stress that is put on the tubes by rotation of the turbocharger housing. Alignment of the turbocharger housing is still critical. The turbocharger housing must not put an external load to the oil drain tubes after installation.
Adaptable To: The new oil drain tubes are adaptable to the engines that are listed above, if equipped. All the former parts are cancelled and replaced by the new parts that are listed in Table 1.
Show/hide table
Former Parts and New Parts     | ||
Former Part     | New Part     | Description     |
116-3261     | 284-1054     | Tube     |
116-3262     | 284-1056     | Tube     |
136-3298     | 278-0521     | Tube     |
246-5532     | 278-9545     | Tube     |
7E-5338     | 278-9544     | Tube     |
1W-7990     | 278-9542     | Tube     |
Caterpillar Information System:
C27 and C32 Generator Set Engines Crankshaft Front Seal - Install
C3.3 and C4.4 Rental Generator Sets Before Towing
TH31-E61 and TH35-E81 Petroleum Transmissions Lifting and Tying Down the Transmission
C27 and C32 Generator Set Engines Crankshaft Front Seal - Remove
C175 Generator Set Engines Engine Oil Pan - Install
CX35 On-Highway Transmission Oil Filter (Transmission) - Replace
TH31-E61 and TH35-E81 Petroleum Transmissions Lubricant Viscosities
C32 Petroleum Generator Sets Generator Operation
C15-XQ400 Rental Generator Set Setup
C27 and C32 Generator Set Engines Vibration Damper and Pulley - Remove and Install
C175 Generator Set Engines Flywheel Housing - Install
330D and 336D Excavators Leaving the Machine
TH31-E61 and TH35-E81 Petroleum Transmissions Capacities (Refill)
C15-XQ400 Rental Generator Set Fan Drive Bearing - Lubricate
325D and 329D Excavators and 325D Material Handler Machine System Specifications Pilot Valve (Boom Drift Reduction)
C9 On-highway Engine Flywheel Housing
TH31 Well Servicing Transmissions Pump Drive - Disassemble
C6.6 Marine Generator Set Engine Will Not Crank
C6.6 Marine Generator Set Excessive Fuel Consumption
C4.4 Generator Set Engines Intermittent Engine Shutdown
C6.6 Generator Set Diagnostic Code Cross Reference
C6.6 Generator Set E361 High Engine Coolant Temperature
C6.6 Generator Set E539 High Intake Manifold Air Temperature
C27 and C32 Generator Set Engines Engine Support (Front) - Remove and Install