Fuel Manifold - Install
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 检查 O 形密封圈的状况。 必要时，更换密封件。
Show/hide table
图 1 g00846262 - 安装螺塞 (5) 和 O 形密封圈。
- 将 O 形密封圈 (4) 安装在燃油歧管 (1) 上。
Show/hide table
图 2 g00846247 - 用螺栓 (3) 和垫圈将燃油歧管 (1) 安装在气缸盖上。
- 安装线束组件和螺栓 (2)。 将全部螺栓上紧到
28 ± 7 N·m (21 ± 5 lb ft) 的扭矩。
结束:
- 安装燃油滤清器底座。 请参阅拆解和组装, "燃油滤清器底座 - 拆卸和安装"。
Caterpillar Information System:
G3300 Engines Valve Stem Projection - Measure/Record
G3300 Engines Turbocharger - Inspect
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Remove
3116 and 3126 Marine Engines Sensors and Electrical Components
C9 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
C9 Engine For Caterpillar Built Machines Alternator - Remove and Install
G3300 Engines Crankcase Blowby - Measure/Record
3176C Industrial Engine Belt Tightener - Remove and Install
3612 and 3616 Engines Water Temperature Regulator
Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000} Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000}
3500B and 3500B High Displacement Generator Set Engines Exhaust Temperature Is Too High
3406E On-Highway Engine Turbocharger - Assemble
G3300 Engines Overhaul Considerations
G3300 Engines Overhaul (Top End)
G3300 Engines Overhaul (Major)
3612 and 3616 Engines Cylinder Liner
Electronic Modular Control Panel II+ (EMCP II+) Component Location - For 3306B and 3406C MUI Engines
3612 and 3616 Engines Piston and Rings - Four Ring Piston
3176C and 3196 Engines For Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
G3300 Engines Alarms and Shutoffs
3176C and 3196 Engines For Caterpillar Built Machines Electronic Control Module - Remove and Install
3406C (PEEC III) Truck Engines Lubrication System
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types I, II, III, and IV)
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types V, VI, and VII)