Belt Tightener - Remove and Install
Removal Procedure
- Use a breaker bar to release the tension on belt tightener (1). Remove the drive belt.
Show/hide table
Illustration 1 | g00519255 |
- Remove bolt (4) and the washer.
Show/hide table
Illustration 2 | g00519256 |
- Remove belt tightener (1) .
- Remove three bolts (2) and the washers.
- Remove support (3) .
Installation Procedure
- Inspect the condition of the belt tightener and the drive belt. Replace the tightener and the belt, if necessary.
- Install support (3) on the front housing with three bolts (2) and the washers. Tighten the bolts to a torque of 55 ± 10 N·m (41 ± 7 lb ft).
Show/hide table
Illustration 3 | g00519256 |
- Install belt tightener (1) with bolt (4) and the washer. Tighten the bolt to a torque of 55 ± 10 N·m (41 ± 7 lb ft).
- Install the drive belt. Use a breaker bar to place the original amount of tension on the belt.
- If the alternator is equipped with an adjustable support strap, adjust the position of the alternator until the indicator edge (5) is aligned with the green area of the indicator decal.
Show/hide table
Illustration 4 | g00519259 |
Caterpillar Information System:
3612 and 3616 Engines Water Temperature Regulator
Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000} Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000}
3500B and 3500B High Displacement Generator Set Engines Exhaust Temperature Is Too High
3406E On-Highway Engine Turbocharger - Assemble
3516B Engine for Caterpillar Built Machines Fuel Dilution of Engine Oil
3524B Engines for Off-Highway Trucks Coolant Temperature Is Too High
3606 and 3608 Engines Exhaust Manifold
3524B Engines for Off-Highway Trucks Low Engine Oil Pressure
3516B Engine for Caterpillar Built Machines Engine Has Early Wear
3500B and 3500B High Displacement Generator Set Engines Oil Contains Coolant
3176C Engine Cooling System Coolant (ELC) - Change
3524B Engines for Off-Highway Trucks Fuel in Cooling System
G3300 Engines Crankcase Blowby - Measure/Record
C9 Engine For Caterpillar Built Machines Alternator - Remove and Install
C9 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
3116 and 3126 Marine Engines Sensors and Electrical Components
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Remove
G3300 Engines Turbocharger - Inspect
G3300 Engines Valve Stem Projection - Measure/Record
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Install
G3300 Engines Overhaul Considerations
G3300 Engines Overhaul (Top End)
G3300 Engines Overhaul (Major)
3612 and 3616 Engines Cylinder Liner