Turbocharger - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Compressor housing must go straight on the turbocharger assembly without tilting. Tilting may cause compressor blade to tip, or the compressor shaft can be damaged. |
Show/hide table
Illustration 1 | g00513699 |
- Check condition of all components. Use new parts to replace worn or damaged parts.
- Connect compressor housing (2) and turbine housing (5) to turbocharger cartridge (4).
- Tighten the nuts on V-band clamps (3) to a torque of
14 ± 3 N·m (10 ± 2 lb ft) . Use a soft hammer to lightly hit around the diameter of band clamps (3). - Tighten the nuts on V-band clamps (3) again. Tighten to a torque of
14 ± 3 N·m (10 ± 2 lb ft) .Show/hide tableIllustration 2 g00513698 - Install clamp (1) on waste gate.
Caterpillar Information System:
3516B Engine for Caterpillar Built Machines Fuel Dilution of Engine Oil
3524B Engines for Off-Highway Trucks Coolant Temperature Is Too High
3606 and 3608 Engines Exhaust Manifold
3524B Engines for Off-Highway Trucks Low Engine Oil Pressure
3516B Engine for Caterpillar Built Machines Engine Has Early Wear
3500B and 3500B High Displacement Generator Set Engines Oil Contains Coolant
3176C Engine Cooling System Coolant (ELC) - Change
3524B Engines for Off-Highway Trucks Fuel in Cooling System
3176C and 3196 Industrial Engines Speed/Timing Sensor - Remove and Install
3176C and 3196 Industrial Engines Engine Oil Pressure Sensor - Remove and Install
G3300 Engines Cooling System Coolant (DEAC) - Change
C-10 and C-12 Truck Engines Compression Brake
3500B and 3500B High Displacement Generator Set Engines Exhaust Temperature Is Too High
Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000} Installation And Initial Start Up Procedures For G3300 And G3400 Engines{1000}
3612 and 3616 Engines Water Temperature Regulator
3176C Industrial Engine Belt Tightener - Remove and Install
G3300 Engines Crankcase Blowby - Measure/Record
C9 Engine For Caterpillar Built Machines Alternator - Remove and Install
C9 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
3116 and 3126 Marine Engines Sensors and Electrical Components
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Remove
G3300 Engines Turbocharger - Inspect
G3300 Engines Valve Stem Projection - Measure/Record
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Install