Cylinder Liner
Show/hide table
 | |
| 图 1 | g00536351 |
(1) 燃烧密封垫槽
- 槽深 ... 3.50 ± 0.03 mm (0.138 ± 0.001 in)
- 尺寸变化一定不能超过以下值。 ... 0.020 mm (0.0008 in)
(2) 新衬垫的大孔 ... 290.025 ± 0.025 mm (11.4183 ± 0.0010 in)
(3) 法兰
- 法兰厚度 ... 33.00 ± 0.03 mm (1.299 ± 0.001 in)
- 尺寸变化一定不能超过以下值。 ... 0.013 mm (0.0005 in)
(4) 新衬垫的小孔 ... 280.025 ± 0.025 mm (11.0246 ± 0.0010 in)
Caterpillar Information System:
G3300 Engines Overhaul (Major)
G3300 Engines Overhaul (Top End)
G3300 Engines Overhaul Considerations
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Install
G3300 Engines Valve Stem Projection - Measure/Record
G3300 Engines Turbocharger - Inspect
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Remove
3116 and 3126 Marine Engines Sensors and Electrical Components
C9 Engines for Caterpillar Built Machines Electric Starting Motor - Remove and Install
C9 Engine For Caterpillar Built Machines Alternator - Remove and Install
G3300 Engines Crankcase Blowby - Measure/Record
3176C Industrial Engine Belt Tightener - Remove and Install
Electronic Modular Control Panel II+ (EMCP II+) Component Location - For 3306B and 3406C MUI Engines
3612 and 3616 Engines Piston and Rings - Four Ring Piston
3176C and 3196 Engines For Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
G3300 Engines Alarms and Shutoffs
3176C and 3196 Engines For Caterpillar Built Machines Electronic Control Module - Remove and Install
3406C (PEEC III) Truck Engines Lubrication System
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types I, II, III, and IV)
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types V, VI, and VII)
G3300 Engines Emergency Stopping
3176C and 3196 Industrial Engines Fuel Filter Base - Remove and Install
3176C Industrial Engine Rear Power Take-Off (RPTO) - Remove and Install
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types I and IV)