Emergency Stopping
Show/hide table
| 注意 |
|---|
紧急停机控制装置只用于紧急情况。 切勿把紧急停机装置或控制装置用于正常的停机过程。 |
在发动机停机之后，确保为发动机运行提供外部支持的所有系统是安全可靠的。
Show/hide table
| 注意 |
|---|
在找到迫使发动机紧急停机的问题并予以纠正以前，不要起动发动机。 |
按紧急停机按钮可能造成未燃烧气体残留在空气进气管和排气管里。
Show/hide table
 |
当发动机被起动时，进排气系统里残存的燃气可能被点燃。 可能造成人身伤害和/或财产损失。 起动一台含未燃烧的燃气的发动机之前，从进排气系统清除这些未燃烧的燃气。 参阅"起动发动机"有关清除未燃烧燃气的章节。 |
紧急停机按钮
Show/hide table
 | |
| 图 1 | g00520710 |
接线盒上的紧急停机按钮 | |
发动机正常运转时，接线盒上的紧急停机按钮处于弹出位置。 需要紧急停机时，按下紧急停机按钮。 必须将此按钮复位之后才能起动发动机。
顺时针旋转该按钮，将其复位。 弹簧加载的按钮会回到弹出位置。
Show/hide table
 | |
| 图 2 | g00841956 |
仪表板上的紧急停机按钮 (1) "STOP（停机）" 按钮 (2) "RESET（复位）" 按钮 | |
在仪表板上，按下"停机"按钮以进行紧急停机。
必须将仪表板复位之后才能起动发动机。 按下"复位"按钮以复位仪表板。
Caterpillar Information System:
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types V, VI, and VII)
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types I, II, III, and IV)
3406C (PEEC III) Truck Engines Lubrication System
3176C and 3196 Engines For Caterpillar Built Machines Electronic Control Module - Remove and Install
G3300 Engines Alarms and Shutoffs
3176C and 3196 Engines For Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3612 and 3616 Engines Piston and Rings - Four Ring Piston
Electronic Modular Control Panel II+ (EMCP II+) Component Location - For 3306B and 3406C MUI Engines
3612 and 3616 Engines Cylinder Liner
G3300 Engines Overhaul (Major)
G3300 Engines Overhaul (Top End)
G3300 Engines Overhaul Considerations
3176C and 3196 Industrial Engines Fuel Filter Base - Remove and Install
3176C Industrial Engine Rear Power Take-Off (RPTO) - Remove and Install
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types I and IV)
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types V, VI, and VII)
3406C (PEEC III) Truck Engines Air Inlet and Exhaust System
3114, 3116 and 3126 MUI Engine Governors Governor Servo (Types I, III, IV, V, VI, and VII)
3114, 3116 and 3126 MUI Engine Governors Dashpot (Types I, III, IV, V, VI, and VII)
G3300 Engines Governors and Actuators
3114, 3116 and 3126 MUI Engine Governors Governor Bias Spring (Most Types IV, V, and VI)
3114, 3116 and 3126 MUI Engine Governors Governor Bumper Spring (Some Type IV)
3114, 3116 and 3126 MUI Engine Governors Dual Horsepower (Type VI)
3406C (PEEC III) Truck Engines Basic Block