Electronic Control Module - Remove and Install
Removal Procedure
- Remove nut (1), the washer, and clip (2) .
Show/hide table
Illustration 1 | g01023070 |
- Loosen bolt (7) until harness assembly (8) can be disconnected. Disconnect harness assembly (8) .
- Remove nuts (6) and the washers. Move hose assembly (5) out of the way. Remove plate (3) .
- Remove bolt (9) and the washer. Remove studs (4) and the washers. Remove the electronic control module from the engine.
Installation procedure
- Position the electronic control module on the engine and install studs (4) and the washers.
Show/hide table
Illustration 2 | g01023070 |
- Install bolt (9) and the washer.
- Install hose assembly (5) and plate (3). Install nuts (6) .
- Connect harness assembly (8). Tighten bolt (7) to a torque of 6 ± 1 N·m (53 ± 9 lb in).
- Install clip (2), the washer, and nut (1) .
Caterpillar Information System:
G3300 Engines Alarms and Shutoffs
3176C and 3196 Engines For Caterpillar Built Machines Coolant Temperature Sensor - Remove and Install
3612 and 3616 Engines Piston and Rings - Four Ring Piston
Electronic Modular Control Panel II+ (EMCP II+) Component Location - For 3306B and 3406C MUI Engines
3612 and 3616 Engines Cylinder Liner
G3300 Engines Overhaul (Major)
G3300 Engines Overhaul (Top End)
G3300 Engines Overhaul Considerations
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Install
G3300 Engines Valve Stem Projection - Measure/Record
G3300 Engines Turbocharger - Inspect
3176C and 3196 Engines For Caterpillar Built Machines Fuel Manifold - Remove
3406C (PEEC III) Truck Engines Lubrication System
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types I, II, III, and IV)
3114, 3116 and 3126 MUI Engine Governors Governor Limiting Circuit (Types V, VI, and VII)
G3300 Engines Emergency Stopping
3176C and 3196 Industrial Engines Fuel Filter Base - Remove and Install
3176C Industrial Engine Rear Power Take-Off (RPTO) - Remove and Install
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types I and IV)
3114, 3116 and 3126 MUI Engine Governors Fuel Ratio Control (Types V, VI, and VII)
3406C (PEEC III) Truck Engines Air Inlet and Exhaust System
3114, 3116 and 3126 MUI Engine Governors Governor Servo (Types I, III, IV, V, VI, and VII)
3114, 3116 and 3126 MUI Engine Governors Dashpot (Types I, III, IV, V, VI, and VII)
G3300 Engines Governors and Actuators