Transmission Charging Pump Pressure - Test
Show/hide table
在调试变速箱传动系统时,把机器开到没有障碍物和安全通风排气的地方。 机器的突然动作或在压力下放油,可能对机上或机器附近人员造成伤害。 为避免造成伤害,在调试变速箱传动系统之前,必须遵照下列程序。 |
Show/hide table
注意 |
---|
在检验、保养、测试、调整及维修机器时,务必备妥盛接流出液体的容器。 在打开任何腔室或拆解任何储有液体的部件之前,要准备好用合适的容器收集液体。 按照本地法规和指令处置所有液体。 |
测试前,参考系统操作、测试和调整, "机器故障诊断和排除准备工作"。
Show/hide table
所需工具     | ||
零件号     | 描述     | 数量     |
1U-5481     | 压力表总成     | 1     |
1U-5482     | 压力适配器总成     | 1     |
8T-0856     | 压力表 (0 至6,000 kPa (0 至 870 psi))     | 1     |
- 开动机器,直至变速箱油达到其工作温度 51 °C (124 °F)。
- 停下机器。 接合停车制动器并把发动机关闭。
- 在变速箱泵 (2) 的测压孔 (1) 装上 8T-0856 压力表 (0 至 6,000 kPa (0 至 870 psi)) 。
Show/hide table
图 1 | g00109926 |
离开机器尾部 (1) 测试口 (2) 变速箱泵 |
- 起动发动机。 把油门设到高怠速位置。 把差速器锁定转到 合上 位置。 参考图表2 以取得正确的变速箱油压力。 在图表3上记录压力表的读数。
Show/hide table
表 2 变速箱油压力(最低)     低怠速下 空档 位置。     高怠速下 空档 位置。    
2690 kPa (390 psi)    
3240 kPa (470 psi)    Show/hide table表 3 变速箱机油压力表     低怠速下 空档 位置。     高怠速下 空档 位置。            
- 发动机在低怠速下转动,重复步骤1 至步骤4。
Caterpillar Information System:
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0709 - FMI 06
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0709 - FMI 05
2002/06/24 Correction to Specifications , "Pressure Control Valve (Transmission)" {3074}
RM-350B Reclaimer Mixer Machine Electronic Control System Using Caterpillar Monitoring System to Determine Diagnostic Codes
938G Series II Wheel Loader and IT38G Series II Integrated Toolcarrier Engine Oil Level - Check
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0709 - FMI 03
3056E Industrial Engine Crankshaft Seals
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 1428 - FMI 03
247 and 257 Multi Terrain Loaders Loader Frame
3056E Industrial Engine Water Temperature Regulator
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0673 - FMI 08
3056E Industrial Engine Engine Oil Pan
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0826 - FMI 03
Instructions for Updating the CABSDos Software and Reinstalling the CABSDos Software{7610, 7620} Instructions for Updating the CABSDos Software and Reinstalling the CABSDos Software{7610, 7620}
2002/05/27 Preparation of Air Conditioner Units for Seasonal Use {7320}
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0826 - FMI 04
797 and 797B Off-Highway Truck Power Train Electronic Control System MID 081 - CID 0967 - FMI 02
2002/04/01 Change to Specifications Manual {1157}
Installation Procedure for Installing a Blade on 574 Forwarders{6060} Installation Procedure for Installing a Blade on 574 Forwarders{6060}
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Transmission Pressures - Test
C-9 Engine for MT735, MT745, MT755, MT765, MTC735, MTC745, MTC755, and MTC765 Agricultural Tractors System Configuration Parameters
IQAN<COMP-BREAK TAGNAME=cp850>©<COMP-RESUME> Monitoring ; Control System Retrieving and Saving Parameter Files
2002/04/01 New Connectors are Used on the Gear Shift Harness {1408}
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Initial Pressures - Test and Adjust