Removal Procedure
Start By:
- Remove the vibratory pump. Refer to Disassembly and Assembly, "Vibratory Pump - Remove".
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
Note: Put identification marks on all lines, on all hoses, on all wires and on all tubes for installation purposes. Plug all lines, all hoses and all tubes. This will help to prevent fluid loss and this will help to keep contaminants from entering the system.
- Remove hose assemblies (1) from propel pump (2) .
 | |
| Illustration 1 | g00853187 |
- Remove hose assemblies (3) from propel pump (2) .
 | |
| Illustration 2 | g00853188 |
- Disconnect electrical connector (4) . Remove electrical connector (4) from the clip. Remove the tie strap that fastens electrical connector (4) to the bracket.
 | |
| Illustration 3 | g00853190 |
- Attach a lifting strap and a hoist to propel pump (2) . Remove two bolts (5) and remove propel pump (2) from the engine. The weight of the propel pump is 42 kg (93 lb).
 | |
| Illustration 4 | g00853192 |
- Loosen bolt (6) and remove coupling hub (7) from piston pump (2) .
 | |
| Illustration 5 | g01337956 |