914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Caterpillar


Transmission Control (Shift Lever)

Usage:

IT14G 1WN
测试步骤 1. 检查电压

从线束上断开十二针接头。 检查针 2 和针 4 之间的系统电压。 跨接十二针接头。 请参考图。 进行下列测试。




图 1g00853179

注: 请勿断开四针换档把手接头。

  • 把手处于空档位置

  • 换挡把手上的针 5应等于蓄电池正极。

  • 换挡把手上的针 7应等于蓄电池正极。

  • 把手处于前进档位置

  • 蓄电池正极电压应在针 11 和针 12 之间读取。

  • 把手处于倒档位置

  • 蓄电池正极电压应在针 9 和针 10 之间读取。 针 3 应等于蓄电池正极电压。

  • 将 F/N/R 开关置于空档。 确保四针接头已连接。

  • 重新连接十二针接头。

  • 对于 ECM,测量换档操纵杆线束上的电压。 按照参考,测量针 2 的电压。 请参见下表。

表 1
    电压    
4     蓄电池正极    
9     +5 VDC    
10     1/2 蓄电池正极    
11     +5 VDC    
12     1/2 蓄电池正极    

结果:

  • 电压测量值指出故障区域。 -

    修复: 修理该故障。

    停止

Caterpillar Information System:

834G Wheel Tractor and 836G Landfill Compactor Engine Supplement Radiator Top Tank - Install
2002/01/21 Changes to the Rear Spindle and to the Bearing Cone {4208, 4234, 7551}
CB-634D Vibratory Compactor Machine Systems Brake Pump - Remove and Install
CB-634D Vibratory Compactor Machine Systems Vibratory Valve - Install
CB-634D Paving Compactor Water Tank Strainer - Clean and Inspect
CB-634D Paving Compactor Water Spray System Filter - Clean
CB-634D Vibratory Compactor Machine Systems Vibratory Valve - Remove
CB-634D Paving Compactor Water Spray System - Drain
Instructions for Updating the CABSWin Software and for Reinstalling the CabsWin Software{7620} Instructions for Updating the CABSWin Software and for Reinstalling the CabsWin Software{7620}
CB-634D Vibratory Compactor Machine Systems Brake and Shift Valve - Install
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Remote Direction Control
120H and 135H Motor Graders Ripper Cylinder Bearings - Lubricate
533 Wheel Feller Buncher and 543 Wheel Feller Buncher Power Train Monitoring System
2003/12/01 Maintaining the Mechanical Linkage Between the Engine Flywheel and the Hydrostatic Pump {3203, 5070}
CB-634D Vibratory Compactor Machine Systems Piston Pump (Vibratory) - Remove
CB-634D Vibratory Compactor Machine Systems Piston Pump (Vibratory) - Install
CB-634D Vibratory Compactor Machine Systems Piston Pump (Drum Propel) - Remove
2002/03/01 Procedure For Cleaning Engine Bolts {1000}
2002/05/27 A Special Instruction, REHS1228, "Field Installation of the Open Circuit Oil Breather Gp (Engine Kit)" Is Available {1058}
834G Wheel Tractor and 836G Landfill Compactor Engine Supplement Fan Group (Includes Fan, Fan Shroud, and Hydraulic Fan Motor) - Install
CB-634D Vibratory Compactor Machine Systems Piston Pump (Drum Propel) - Install
3176C, 3196 and 3406E Engines for 725, 730, 735, 740, and 740 Ejector Articulated Trucks Engine Fan Control Solenoid Circuit - Test
AS2251 Screed Mix Height Control
2002/05/27 Addition to Testing and Adjusting , "Torque Converter Stall - Test" {3101}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.