2000/08/21 Caterpillar

Articulated Truck:

D350E Series II (PIN: 2XW1-UP)

D400E Series II (PIN: 8PS1-UP)

Testing and Adjusting, RENR3400, "D350E Series II and D400E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems", "Gear Pump (Hoist) - Test and Adjust"Testing and Adjusting, RENR3400, "D350E Series II and D400E Series II Articulated Trucks Steering, Suspension, and Body Hoist Hydraulic Systems", "Relief Valve (Hoist Raise) - Test and Adjust"

Step 4 on page 25 of Testing and Adjusting, "Gear Pump (Hoist) - Test and Adjust" is incorrect. Step 3 on page 26 and Step 3 on page 27 of Testing and Adjusting, "Relief Valve (Hoist Raise) - Test and Adjust" are incorrect. Replace all three steps with the following paragraph:

Make sure that there is enough overhead room in order to fully raise the dump body. Start the engine and run the engine at high idle. Fully raise the dump body and hold the hoist lever in the RAISE position. The pressure should read 22500 ± 340 kPa (3300 ± 50 psi).