Vibration Damper and Pulley - Remove and Install
Show/hide table
工具 | 零件号 | 零件说明 | 数量 |
---|---|---|---|
A | - | 5/8 in-NF X 7 in 长导向螺栓 | 2 |
- 将尼龙带和起重机固定到皮带轮 (2) 上。
- 拆下两条螺栓 (1) 后安装工具 (A)。
- 拆下其余的螺栓 (1)。
- 拆下皮带轮 (2)。 皮带轮的重量为
32 kg (71 lb) 。Show/hide table图 2 g00719530 - 拆下减振器 (3)。
Show/hide table
图 3 g00719523 - 拆下隔套 (4) 和过渡接头 (5)。
Show/hide table
图 1 | g00719482 |
Show/hide table
工具 | 零件号 | 零件说明 | 数量 |
---|---|---|---|
A | - | 5/8 in-NF X 7 in 长导向螺栓 | 2 |
- 将工具 (A) 安装到曲轴中。
- 安装过渡接头 (5) 和隔套 (4)。
Show/hide table
图 5 g00719530 - 安装减振器 (3)。
Show/hide table
图 6 g00719482 - 安装皮带轮 (2)。
- 利用干净的机油轻轻润滑螺栓的螺纹。 安装四个螺栓 (1)。 拆下工具 (A)。 安装最后两条螺栓。
拧紧螺栓 (1) 至扭矩为
215 ± 40 N·m (159 ± 30 lb ft) 。
Show/hide table
图 4 | g00719523 |
Caterpillar Information System:
2000/08/21 Correction to Disassembly and Assembly , "Differential and Bevel Gear - Assemble" {3256, 3258}
938G Wheel Loader and IT38G Integrated Toolcarrier Hydraulic System Check Valve (Pilot)
416D, 420D, 424D, 428D, 430D, 432D and 442D Backhoe Loaders Extendable Stick Pads - Inspect/Replace - If Equipped
PF-300B and PS-300B Pneumatic Compactors Propel System General Information
416C, 426C, 428C, 436C and 438C Backhoe Loaders Parking
3176C and 3196 Engines For Caterpillar Built Machines Water Pump - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump Drive - Install
420D and 430D Backhoe Loaders Engine Oil and Filter - Change
420D and 430D Backhoe Loaders Engine Oil Level - Check
416D Backhoe Loader Engine Air Filter Service Indicator - Inspect
2006/08/21 Replacement Instructions for the Oil Level Gauge on the Brake, Steering and Hoist Tank {5056, 7450}
988G Wheel Loader Electrohydraulic System Pilot Control Actuator Pressure - Check
2000/08/21 Correction to Testing and Adjusting , "Gear Pump (Hoist) - Test and Adjust and Relief Valve (Hoist Raise) - Test and Adjust" {5073, 5073, 5083, 5083, 5136, 5136}
3054B Engine for Caterpillar Built Machines Fuel System Pressure - Test
2000/06/26 Proper Gear Installation Improves Service Life {5058}
938G Wheel Loader and IT38G Integrated Toolcarrier Machine Systems Quick Coupler - Install
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Propel System Wheel and Tire
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Propel System Pressure Control Valve - Shift Valve
424D, 428D and 438D Backhoe Loaders Final Drive Oil (Front) - Change
CP-563D, CS-563D, CS-573D and CS-583D Vibratory Compactors Propel System Drum Drive
424D, 428D and 438D Backhoe Loaders Final Drive Oil Level (Front) - Check
420D and 430D Backhoe Loaders Fuel System Water Separator - Drain
424D, 428D and 438D Backhoe Loaders Fuses - Replace
420D and 430D Backhoe Loaders Hydraulic System Oil Filter - Replace