Hoist Cylinder - Install
Show/hide table
 |
|
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
Show/hide table
| NOTICE |
|---|
|
To prevent dirt and contaminants from entering the hydraulic system, always plug or cap the lines, fittings, or hoses as they are disconnected. This action also lessens the chance of oil spills. |
- Inspect all parts and clean all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
Show/hide table
Illustration 1 g00567578 - Use an appropriate lifting strap and a hoist to position hoist cylinder (3) on the dump body.
- Install pin assembly (6) on the bracket. Install bolt (4), the washer and the spacer on pin assembly (6). Install grease nipple (5) and fitting (7) on pin assembly (6).
Show/hide table
Illustration 2 g00567577 - Install two bolts (2) on hoist cylinder (3). Connect two hoses (1) on hoist cylinder (3). Install the O-ring seals to two hoses (1).
- Remove the lifting straps and the hoist from the hoist cylinder.
Caterpillar Information System:
784C and 785C Off-Highway Truck Power Train Transmission Planetary and Transfer Gears - Install
3054 Engine for Caterpillar Built Machines Fuel Injection Pump - Install - Type 2 Engines and 7BJ Engines
554 Forwarder and 574 Forwarder Secondary Disconnect Switch
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems Mode 11 - Three-Point Hitch Status and Calibration
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Systems Steering Control - Assemble
D400E Series II Articulated Truck Front Suspension Cylinder - Remove
D350E Series II Articulated Truck Hoist Cylinder - Remove
3116 Engine for Challenger 35, and Challenger 45 Agricultural Tractors and 3126 Engine for Challenger 55 Agricultural Tractor Engine Supplement Engine Support - Remove and Install
AP-1050B and BG-245C Asphalt Pavers Turbocharger - Inspect
24H Motor Grader Hydraulic and Steering System Relief Valve (Steering Cylinder Crossover)
3512B and 3516B Engine Supplement for and 784C,, 785C and and 785C HAA Off-Highway Truck/Tractors Battery - Remove and Install
Retrofitting the 136-7822 Transmission Control for the 109-3664 Transmission Control {3065} Retrofitting the 136-7822 Transmission Control for the 109-3664 Transmission Control {3065}
CB-634C Vibratory Compactor Parking Brake Control
416C, 426C, 428C, 436C and 438C Backhoe Loaders Hydraulic and Steering System Load Control Valve (Lift)
24H Motor Grader Hydraulic and Steering System Unloading Valve (Secondary Steering)
CB-634C Vibratory Compactor Propel Control
216, 226, 228, 232, 236, 242, 246, 248, 252 and 262 Skid Steer Loaders Window Wiper - Inspect/Replace - If Equipped
24H Motor Grader Hydraulic and Steering System Steering Hydraulic System Oil Flow
Challenger 65C, Challenger 65D, Challenger 65E, Challenger 70C, Challenger 75C, Challenger 75D, Challenger 75E, Challenger 85C, Challenger 85D, Challenger 85E and Challenger 95E Agricultural Tractors Machine Monitor System Machine Monitor Faults
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Systems Compensator Valve - Remove
CB-634C Vibratory Compactor Propel Speed Range Control
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Systems Compensator Valve - Install
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Machine Systems Compensator Valve - Disassemble
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Electronic Systems Wire Description