Make sure that all of the warning signs are legible. Clean the warning signs or replace the warning signs if you cannot read the words. Replace the illustrations if the illustrations are not visible. When you clean the warning signs, use a cloth, water and soap. Do not use solvent, gasoline, or other harsh chemicals to clean the warning signs. Solvents, gasoline, or harsh chemicals could loosen the adhesive that secures the warning sign. Loose adhesive will allow the warning sign to fall.
Replace any warning sign that is damaged, or missing. If a warning sign is attached to a part that is replaced, install a warning sign on the replacement part. Any Caterpillar dealer can provide new warning signs.
Do Not Operate
Illustration 1 | g00331983 |
The warning sign is located in the operator's compartment on the left side next to the operator's seat.
DO NOT OPERATE OR WORK ON THIS MACHINE UNLESS YOU HAVE READ AND UNDERSTAND THE INSTRUCTIONS AND WARNINGS IN THE OPERATION AND MAINTENANCE MANUALS. FAILURE TO FOLLOW THE INSTRUCTIONS OR HEED THE WARNINGS COULD RESULT IN INJURY OR DEATH. CONTACT ANY CATERPILLAR DEALER FOR REPLACEMENT MANUALS. PROPER CARE IS YOUR RESPONSIBILITY. |
Do Not Weld or Drill Holes In The ROPS Or The FOPS
Illustration 2 | g00508569 |
The warning sign is located on the ROPS or the FOPS.
Structural damage, an overturn, modification, alteration, or improper repair can impair this structure's protection capability thereby voiding this certification. Do not weld on or drill holes in the structure. Consult a Caterpillar dealer to determine this structure's limitations without voiding its certification. |
The serial number prefix BDW has a Non-ROPS canopy.
High Pressure Cylinder
Illustration 3 | g00331985 |
The warning sign is located on both track roller frames.
High Pressure Cylinder. Do Not remove any parts until all pressure has been relieved to avoid possible personal injury. Relieve pressure by opening relief valve one turn maximum. See the Operation and Maintenance Manual for correct procedure. |
Inspect Assembly For Cracks
Illustration 4 | g00331986 |
The warning sign is located on the track roller frames.
Stop disassembly if evidence of a crack exists in the tube or slot beneath this guide. A cracked tube can break suddenly expelling pieces with great force that could result in serious injury or death. Contact a Caterpillar dealer for special disassembly instructions. |
Jump Start Cable Connections
Illustration 5 | g00508572 |
The warning sign is located in the battery compartment.
IMPROPER JUMPER CABLE CONNECTIONS CAN CAUSE EXPLOSION RESULTING IN PERSONAL INJURY. BATTERIES MAY BE LOCATED IN SEPARATE COMPARTMENTS. WHEN USING JUMPER CABLES, ALWAYS CONNECT POSITIVE (+) CABLE TO POSITIVE (+) TERMINAL OF BATTERY CONNECTED TO STARTER SOLENOID AND NEGATIVE (-) CABLE FROM EXTERNAL SOURCE TO STARTER NEGATIVE (-) TERMINAL (IF MACHINE NOT EQUIPPED WITH STARTER NEGATIVE TERMINAL, CONNECT TO ENGINE BLOCK.) FOLLOW PROCEDURE IN THE OPERATION MANUAL. |