Engine Oil Cooler - Install
Installation Procedure
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the condition of the gaskets. If the gaskets are worn or damaged, use new parts for replacement.
- Use two technicians to put oil cooler (3), oil cooler bonnet (6) and elbow (5) for the oil cooler into position on the engine as an assembly. The weight of the oil cooler assembly is approximately 24 kg (53 lb).
Show/hide table
 | |
| Illustration 1 | g00495608 |
- Put the oil cooler assembly in position on the engine and install four bolts (1) that hold oil cooler bonnet (6) to the engine.
- Install four bolts (2) that hold the oil cooler bracket to the engine.
- Install two bolts (4) that hold elbow (5) for the oil cooler to the water pump.
End By: Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
784C and 785C Off-Highway Trucks Machine Systems Steering Accumulator - Install
784C and 785C Off-Highway Truck/Tractors Air System and Brakes Hydraulic Tank (Torque Converter, Pulled Unit, Brake, and Transmission)
784C and 785C Off-Highway Truck/Tractors Air System and Brakes Hydraulic Tank (Torque Converter, Hoist, Brake and Transmission)
769D Off-Highway Truck and 771D Quarry Truck Access and Exit Procedures
3306C Engines for Caterpillar Built Machines Cylinder Block
583R Pipelayer Power Train Track Roller - Assemble
784C and 785C Off-Highway Truck/Tractors Air System and Brakes Control Valve (Hoist)
784C and 785C Off-Highway Trucks Machine Systems Metering Pump (Steering) - Install
69D and 769D Off-Highway Truck and 771D Quarry Truck Air System and Brakes Air Control Valve (Retarder)
797 Off-Highway Truck Power Train Transmission Planetary - Assemble
583R Pipelayer Engine Supplement Engine and Torque Divider - Install
CB-434C, CB-534C and CB-634C Vibratory Compactors Water Spray System Water Tank (Front)
583R Pipelayer Engine Supplement Fuel Filter and Base - Remove and Install
IT14G Integrated Toolcarrier and 914G Wheel Loader Machine Systems Gear Pump (Implement, Steering and Brakes) - Disassemble
583R Pipelayer Engine Supplement Fuel Ratio Control - Remove
784C and 785C Off-Highway Truck/Tractors Air System and Brakes Control Valve (Pulled Unit)
583R Pipelayer Engine Supplement Fuel Ratio Control - Install
3304B and 3306B Engines for Caterpillar Built Machines Flywheel - Install
583R Pipelayer Engine Supplement Fuel Ratio Control - Disassemble
3304B and 3306B Engines for Caterpillar Built Machines Pistons and Connecting Rods - Remove
3406E On-Highway Engine Engine Oil Filter Base - Install
583R Pipelayer Power Train Idler - Remove
583R Pipelayer Engine Supplement Fuel Ratio Control - Assemble
CB-534C Vibratory Compactor Before Starting Engine