Stopping the Engine if an Electrical Malfunction Occurs
Turn the engine start switch to the OFF position. If the engine does not stop, perform the following procedure.
- Dismount the machine and turn the battery disconnect switch to the OFF position. If the battery disconnect switch is turned to the OFF position and the engine fails to stop, engine shutdown must be performed manually.
- Open the hood of the machine. Disconnect throttle control cable (1) from governor lever control linkage (2) .
Show/hide table
 | |
| Illustration 1 | g00657008 |
Governor control (1) Throttle control cable (2) Governor lever control linkage (3) Governor control lever | |
- Turn governor control lever (3) in a clockwise direction to the SHUTOFF position. This will stop the fuel supply to the engine.
Note: Engine shutdown should only be performed in this manner as a last resort.
Caterpillar Information System:
Challenger 35, Challenger 45 and Challenger 55 Agricultural Tractors Refill Capacities
69D and 769D Off-Highway Truck and 771D Quarry Truck Power Train Rear Axle Housing and Differential - Remove
D250E Series II and D300E Series II Articulated Trucks Stopping the Engine
D250E Series II and D300E Series II Articulated Trucks Stopping the Machine
D350E Series II and D400E Series II Articulated Trucks Dumping
D250E Series II and D300E Series II Articulated Trucks Hauling
D350E Series II and D400E Series II Articulated Trucks Loading
3176C and 3196 Engines for Caterpillar Built Machines Cylinder Block
D250E Series II and D300E Series II Articulated Trucks 3306B Engine Supplement Muffler - Remove and Install
D350E Series II and D400E Series II Articulated Trucks Operating Technique Information
725C2 Articulated Truck Oscillating Hitch
24H Motor Grader Transmission Electronic Control System And Hydraulic Calibrations Electrical Components And Connector Locations
D250E Series II and D300E Series II Articulated Trucks Lowering the Body with Engine Stopped
IT14G Integrated Toolcarrier and 914G Wheel Loader Power Train Limited Slip Differential - Disassemble
725C2 Articulated Truck Leaving the Machine
950G Wheel Loader, 962G Wheel Loader and IT62G Integrated Toolcarrier Hydraulic System Main Control Valve (Lift and Auxiliary)
5130, 5130B and 5230 Excavators, 784B, 785B, 785C, 789B, 789C, 793B and 793C Off-Highway Truck/Tractors and 992G, 994 and 994D Wheel Loaders Vital Information Management System (VIMS) TPS Service Operation
IT28G Integrated Toolcarrier Caterpillar Approved Attachments
789C Off-Highway Truck Steering System Solenoid and Relief Valve (Steering)
69D and 769D Off-Highway Truck and 771D Quarry Truck Power Train Differential and Bevel Gear - Assemble
69D and 769D Off-Highway Truck and 771D Quarry Truck Power Train Differential and Bevel Gear - Disassemble
69D and 769D Off-Highway Truck and 771D Quarry Truck Power Train Transmission Planetary - Disassemble
69D and 769D Off-Highway Truck and 771D Quarry Truck Power Train Transmission Planetary - Assemble
789C Off-Highway Truck Steering System Metering Pump (Steering)