Removal Procedure
At operating temperature, the hydraulic tank is hot and under pressure. Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin. Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly in order to relieve pressure. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
- Put identification marks on all lines, hoses, wires, and tubes for installation purposes. Plug all lines, hoses and tubes. This helps prevent fluid loss and contamination of the oil system.
- Disconnect two hydraulic hoses (1) from filter base (2) .
Illustration 1 | g00467558 |
- Remove filter housing assembly (3) from filter base (2) .
- Remove eight bolts (5) and four half clamps (4) in order to disconnect two hydraulic hoses (6) from filter base (2) .
Illustration 2 | g00467560 |
- Remove three bolts (7) that secure filter base (2) to the machine frame. Remove filter base (2) from the machine frame. Remove the O-ring seal from the filter base.
Illustration 3 | g00467562 |
Installation Procedure
- Inspect all parts and clean all parts. If any parts are worn or damaged, use new Caterpillar parts for replacement.
- Position filter base (2) to the machine frame. Install three bolts (7) that secure filter base (2) to the machine frame.
Illustration 4 | g00467562 |
- Position two hydraulic hoses (6) to filter base (2) . Install eight bolts (5) and four half clamps (4) in order to connect two hydraulic hoses (6) to filter base (2) .
Illustration 5 | g00467560 |
- Install a new filter in filter housing (3) . Install filter housing assembly (3) to filter base (2) .
Illustration 6 | g00467558 |
- Run the engine briefly. Check the level of the fluid in the transmission. See Operation and Maintenance Manual, SEBU7037 for the correct procedure.