Transmission Oil Filter - Replace
Show/hide table
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Operate the machine in order to warm the transmission oil.
- Park the machine on level ground. Lower the blade to the ground and apply slight downward pressure.
- Engage the parking brake. Stop the engine.
- Open both of the access doors behind the cab.
Show/hide table
 | |
| Illustration 1 | g00275084 |
- Remove the filter housing drain plug and allow the oil to drain into a suitable container.
Show/hide table
 | |
| Illustration 2 | g00281424 |
- Use a strap type wrench to remove the filter housing.
- Remove the used filter element from the filter housing. Dispose of the used element properly.
- Clean the drain plug, the filter housing, and the filter housing base with a clean, nonflammable solvent.
- Inspect the filter housing seal. Replace the seal if the seal is damaged.
- Insert the new filter element into the filter housing.
- Install the filter housing.
- Start the engine. Apply the service brake. Only use the right brake pedal.
- Slowly operate the transmission controls in order to circulate the oil.
- Move the transmission control to the NEUTRAL position. Engage the parking brake. Inspect the entire transmission system for leaks.
- Check the transmission oil level.
Reference: Refer to Operation and Maintenance Manual, "Transmission Oil Level - Check" for the correct procedure.
- Close the access doors.
Caterpillar Information System:
834B and 836 Landfill Compactor Rollover Protective Structure (ROPS) - Inspect
834B and 836 Landfill Compactor Transmission Oil - Change
836G Landfill Compactor and 834G Wheel Dozer Lift Cylinder Lower Swivel Bearing - Lubricate
834B and 836 Landfill Compactor Indicators and Gauges - Test
D6R Track-Type Tractor Engine Starting
834B and 836 Landfill Compactor Hydraulic System Oil Level - Check
834B and 836 Landfill Compactor Radiator Grill - Clean
631E Series II Wheel Tractor-Scrapers Before Starting Engine
834B and 836 Landfill Compactor Seat Suspension - Lubricate
834B and 836 Landfill Compactor Hydraulic System Oil Filter (Tank Filter) - Replace
834B and 836 Landfill Compactor Lift Cylinder Upper Trunnion Bearing - Lubricate
834B and 836 Landfill Compactor Hydraulic System Oil - Change
416C, 426C, 428C, 436C and 438C Backhoe Loaders Seat Belt - Inspect
834B and 836 Landfill Compactor Starting Below 0°C (32°F)
834B and 836 Landfill Compactor Transmission Oil Level - Check
834B and 836 Landfill Compactor Window Wiper - Inspect/Replace
938G Wheel Loader and IT38G Integrated Toolcarrier Windows - Clean
834B and 836 Landfill Compactor Window Washer Reservoir - Fill
CP-433C, CS-431C and CS-433C Paving Compactors Engine Starting with Jump Start Cables
834B and 836 Landfill Compactor After Starting Engine
834B and 836 Landfill Compactor Parking Brake
844 Wheel Dozer Bulldozing
844 Wheel Dozer Ditching
844 Wheel Dozer Side Hill Cut