Torque Check Necessary For Front Support Bracket Bolts When Damper And Pulley Are Removed{1153}
Usage:
3406B (2WB17293-17313, 4PM393-394) Generator Set;
3406C (6TB16027-16039, 3ER556-562) Industrial;
3406C (4TB5265-5289) Marine Engines
The proper amount of torque may have not been initially applied to the bolts that attach the front support bracket to the block. However, sufficient torque was applied to assure that the front support bracket bolts will not loosen. As the result, the torque on these bolts should be checked if the front damper and pulley are removed.
NOTE: Because there is no danger of the bolts becoming loose, it is only necessary to check the front support bracket bolts if the front damper and pulley are removed.
The applicable service manual should be referenced in order to verify the correct torque specification.
Caterpillar Information System:
1996/05/09 Radiators Made With Improved Brass Composition To Add Strength At Crimp Joint{1353}
1996/04/15 Check Valve May Be Needed To Accurately Measure Engine Return Fuel Flow{0706,0774,0782}
1996/04/15 Repair Kits Available For Prelube Pump Groups{1319}
1996/04/15 Remanufactured Cylinder Head Groups Available{1100}
1996/04/15 Engine Configuration And Monitoring System Parameter Programming At Initial Startup{1900,1901}
1996/04/15 New Stainless Steel Plate Prevents Formation Of Rust Within Air Inlet And Exhaust System{1063}
1996/04/15 New Gasket Kits Available{1052,1059,1063,1100,1150,1201,1216,1304,1361,1378,1380}
1996/04/15 129-0372 Primary Fuel Filter/Water Separator Assembly{1260,1263}
1996/04/15 New Gasket For Engines With Water Cooled Exhaust Manifolds{1059}
1996/04/15 New Valve Cover Gasket Helps Prevent Oil Leaks{1107}
1996/03/19 New Liquid Detector Group Used In Jacket Water Low Level Liquid Detector Group{7421}
1996/03/19 New Fault Code Indicates Caterpillar Communication Link Two Problem{1900}
1996/05/09 New Stronger Cylinder Head Bolts Used{1100}
1996/05/09 New Components In Camshaft Groups Provide Increased Lubrication To Thrust Washer Assembly{1210}
1996/05/09 Oil Drainback Holes Changed In New Piston Crown{1225}
1996/05/09 New Integral Seal In Water Lines Groups Helps Prevent Coolant Leaks{1380}
1996/05/09 New Extension For Electronic Ignition System (EIS) Transformer Groups{1409}
1996/05/09 New High Temperature Resistant Seal Group And O-Ring Seal Used In Water Pump Groups{1361}
1996/05/09 Woodward Control Assemblies Have Changed Part Numbers To Provide The CE Marking For Electromagnetic Compatibility (EMC) Directives{1264}
1996/05/09 New Software For The Customer Communication Module{1926}
1996/05/09 New Programmable Logic Control With In-Phase Monitor For Contactor Type Automatic Transfer Switches{4469}
1996/06/12 Check Cooling System If Exhaust Manifold Or Cylinder Head Gasket Is Damaged{1350}
1996/06/12 Part Number And Application Guide For Oil, Fuel And Transmission Pressure Senders And Water Temperature Senders{1924}
1996/06/12 Troubleshooting Information{7569}