Turbocharger
Show/hide table
| |
| Illustration 1 | g06259692 |
|
Typical example | |
Show/hide table
| Item | Qty | Part | Specification Description |
|---|---|---|---|
| 1 | 12 | - | Before assembly, lubricate the threads of nut with Loctite Nickel Anti-Seize.
Tighten the nut to |
| 2 | 15 | - | Before assembly, lubricate the threads of bolt with Loctite Nickel Anti-Seize.
Tighten the bolt to |
| 3 | 1 | 470-3206 Band Clamp | Use the following procedure to tighten the clamp: 1. Before assembly, lubricate the threads with Loctite Nickel Anti-Seize. 2. Torque to 3. Tap lightly all around. 4. Finally, tighten to |
| 4 | 12 | 156-2603 Bolt | Before assembly, lubricate the threads with Loctite Nickel Anti-Seize.
Torque to |
| 5 | 2 | 252-5060 Plug | Torque to |
Caterpillar Information System:
G3516 Engines Camshaft Bearing Position
New Brake Software is Now Available For Certain F Series Large Off-Highway Trucks {7610, 7620} New Brake Software is Now Available For Certain F Series Large Off-Highway Trucks {7610, 7620}
G3516 Petroleum Engines Gear Group (Rear) - Install
3512E and 3516E Marine Engines Turbocharger - Install
G3516 TA Engine Prelube Pump - Air
336 Excavator Machine Systems Refrigerant Receiver-Dryer - Remove and Install
3500E Marine Engines Sound Information
Regulatory Compliance Information General Information
New Exhaust Manifold Brackets Are Now Used on Certain G3500 Engines {0635, 1061} New Exhaust Manifold Brackets Are Now Used on Certain G3500 Engines {0635, 1061}
323F LN Excavator Machine Systems Pump Control (Negative Flow) - Test
G3516 Petroleum Engines Gear Group (Rear) - Remove
XQP1100 Generator Set Configuration Parameters
323F LN Excavator Machine Systems Gear Pump (Pilot) - Test
XQP1100 Generator Set Walk-Around Inspection
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Safety Messages
XQP1100 Generator Set Fuel System Primary Filter (Water Separator) Element - Replace - If Equipped
A New Insulation Assembly and Wing Plates Are Now Used on Certain C175-20 Locomotive Engines {1062, 1091} A New Insulation Assembly and Wing Plates Are Now Used on Certain C175-20 Locomotive Engines {1062, 1091}
XQP1100 Generator Set Belts - Inspect/Adjust/Replace
XQP1100 Generator Set Engine Oil Sample - Obtain
336 Excavator Machine Systems Refrigerant Condenser - Remove and Install
336, 336 GC and 340 Excavator Systems Electronic Control (Machine System) - Assist System
C175 Tier 4 Final Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
326F and 330F Excavator Machine Systems Hydraulic Filter (Pilot)
XQP1100 Generator Set Engine General Information