Camshaft Bearing Position
Show/hide table
| |
| Illustration 1 | g03590293 |
|
Left side view | |
Show/hide table
| Item | Qty | Part | Specification Description |
| Install camshaft bearings into the cylinder block at the following locations: | |||
| - | - | - | Position (A) is |
| - | - | - | Position (B) is |
| - | - | - | Position (C) is |
| - | - | - | Position (D) is |
| - | - | - | Position (E) is |
| - | - | - | Position (F) is |
| - | - | - | Position (G) is |
| - | - | - | Position (H) is |
| - | - | - | Position (J) is |
Caterpillar Information System:
New Brake Software is Now Available For Certain F Series Large Off-Highway Trucks {7610, 7620} New Brake Software is Now Available For Certain F Series Large Off-Highway Trucks {7610, 7620}
G3516 Petroleum Engines Gear Group (Rear) - Install
3512E and 3516E Marine Engines Turbocharger - Install
G3516 TA Engine Prelube Pump - Air
336 Excavator Machine Systems Refrigerant Receiver-Dryer - Remove and Install
3500E Marine Engines Sound Information
Regulatory Compliance Information General Information
New Exhaust Manifold Brackets Are Now Used on Certain G3500 Engines {0635, 1061} New Exhaust Manifold Brackets Are Now Used on Certain G3500 Engines {0635, 1061}
323F LN Excavator Machine Systems Pump Control (Negative Flow) - Test
G3516 Petroleum Engines Gear Group (Rear) - Remove
XQP1100 Generator Set Configuration Parameters
New Improved Emergency Stop Switch Contact Block is Now Used on Certain Gensets {1408, 7418} New Improved Emergency Stop Switch Contact Block is Now Used on Certain Gensets {1408, 7418}
G3516 Engines Turbocharger
323F LN Excavator Machine Systems Gear Pump (Pilot) - Test
XQP1100 Generator Set Walk-Around Inspection
301.5, 301.6, 301.7 CR, 301.8 and 302 CR Mini Hydraulic Excavators Safety Messages
XQP1100 Generator Set Fuel System Primary Filter (Water Separator) Element - Replace - If Equipped
A New Insulation Assembly and Wing Plates Are Now Used on Certain C175-20 Locomotive Engines {1062, 1091} A New Insulation Assembly and Wing Plates Are Now Used on Certain C175-20 Locomotive Engines {1062, 1091}
XQP1100 Generator Set Belts - Inspect/Adjust/Replace
XQP1100 Generator Set Engine Oil Sample - Obtain
336 Excavator Machine Systems Refrigerant Condenser - Remove and Install
336, 336 GC and 340 Excavator Systems Electronic Control (Machine System) - Assist System
C175 Tier 4 Final Engines for Caterpillar Built Machines Nitrogen Oxide Sensor (Exhaust Outlet) - Remove and Install
326F and 330F Excavator Machine Systems Hydraulic Filter (Pilot)