Air Shutoff - Remove and Install
Show/hide table
所需工具 | |||
工具 | 零件号 | 零件描述 | 数量 |
A | 207-1601 | 橡胶润滑剂 | - |
B | - | Loctite C5-A 铜基抗咬合润滑剂 | - |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
弹簧加压的零件和/或盖板可能导致人身伤害。 拆卸盖板时弹簧力将被释放。 松动螺栓时做好准备把持住弹簧加载的盖板。 |
Show/hide table
如果不遵循正确的程序或不使用推荐的工具,可能会对人员造成伤亡。 为避免对人员造成伤亡,应使用推荐的工具遵循已经制定好的程序。 |
Show/hide table
在拆下进气切断装置前,拉动进气切断装置上的跳开关旋钮或按下紧急停止按钮,以释放叶片锁闩。 如果在拆下进气切断装置后释放叶片锁闩,可能导致严重的人身伤害。 |
- 手动释放空气切断阀。 通过拉或压释放空气切断阀上的旋钮。 确保空气切断阀上的指示器径直向下指向"关闭"位置。 如果空气切断阀不触发,请参阅故障诊断与排除, "空气切断阀系统"。
Show/hide table
图 1 g03841723 - 断开线束组件 (1) 和线束组件 (4)。
- 拆下限制开关 (2) 和限制开关 (3)。
Show/hide table
图 2 g03841822 - 拆下带箍 (5)、带箍 (7)、波纹管组件 (6) 和波纹管组件 (8)。
- 拆下螺栓 (9)、螺栓 (11)、管组件 (10)、管组件 (12) 和螺栓。
Show/hide table
图 3 g03841872 - 拆下螺栓 (14)、螺栓 (15)、空气切断阀 (13) 和空气切断阀 (16)。
Show/hide table
图 4 g03842191 - 拆下螺栓 (19)、螺栓 (18)、进气弯头 (17) 和进气弯头 (20)。
- 按与拆卸相反的顺序安装空气切断阀 (16) 和空气切断阀 (13)。
- 将工具 (A) 涂抹到管组件 (12) 和管组件 (10) 的密封件上。
- 按波纹管组件上箭头指示的正确流动方向安装波纹管组件 (8) 和波纹管组件 (6)。
- 将工具 (B) 涂抹到螺纹、轴承表面和带箍 (7) 和带箍 (5) 的内径上。
- 将工具 (B) 涂抹到限制开关 (3) 和限制开关 (2) 的螺纹上。
- 将限制开关 (3) 和限制开关 (2) 拧紧至扭矩为
16 ± 2 N·m (142 ± 18 lb in) 。
Caterpillar Information System:
Reuse & Salvage Procedure for Off-Highway Truck Accumulators {0374, 0599, 0679, 0738, 4269, 4331, 5077} Reuse & Salvage Procedure for Off-Highway Truck Accumulators {0374, 0599, 0679, 0738, 4269, 4331, 5077}
3412 Generator Set Power Is Intermittently Low or Power Cutout Is Intermittent
3512C Generator Set Engine Turbocharger - Assemble
3512C Generator Set Engine Turbocharger - Disassemble
C280-08 Tier 4 Engine Fuel Filter Housings - Remove and Install
3412 Generator Set Oil Pressure Is Low
794 AC Off-Highway Truck Field Assembly Front Axle - Install
2015/06/12 A New Speed Controller and Actuator Are Available for Certain G3400 and G3500 Engines {1264, 1908}
3412 Generator Set Engine Top Speed Is Not Obtained
C280-08 Tier 4 Engine Water Pump Seal - Remove
2015/05/29 Cat® Reman Announces the Availability of Remanufactured Fuel Check Valves Assemblies for G3600 Engines {1106}
2015/06/26 Cat® Reman Is Announcing an Appearance Change to the EI550 Classic, Bridge, and ACERT Electronic Unit Injectors for Certain Truck Engines {1290}
349F and 352F Excavators Machine System Specifications Pump Coupling
3512C Engines for 785C Off-Highway Trucks with Dynamic Gas Blending Electrical Power Supply - Test
3412 Generator Set Sensor Signal (Analog, Active) - Test
C280-08 Tier 4 Engine Priority Valve - Remove and Install
2015/06/23 A New Information Display is Now Used For Certain Cat® Products {7490}
2015/06/05 Recommendations for Cold Weather Operation for C7.1 Generator Set {1225, 1317, 1331}
C280-08 Tier 4 Engine Flywheel and Ring Gear - Remove and Install
3512C Generator Set Engine Aftercooler - Remove and Install
3412 Generator Set Coolant Level - Test
3516B Generator Set Engines with Dynamic Gas Blending High Altitude Derate Occurrence
G3606 and G3608 Engines Water Pump Seal - Remove
C280-08 Tier 4 Engine Crankshaft Rear Gear - Remove and Install