Camshaft
Show/hide table
Illustration 1 | g03345737 |
Show/hide table
Specification for 391-1390 Camshaft Gp     | |||
Item     | Qty     | Part     | Specification Description     |
Before assembly, lubricate the cam bearings, bearing journals, and the camshaft lobes with 50/50 mixture of green 8T-2998 Lubricant and engine oil.     | |||
1     | -     | -     | Diameter of bearing journal is 84.850 ± 0.020 mm (3.3405 ± 0.0008 inch).     |
2     | 3     | 119-0036 Flat Head Screw     | Torque to 13 ± 3 N·m (115 ± 27 lb in).     |
Show/hide table
Illustration 2 | g03345751 |
Show/hide table
Item     | Qty     | Part     | Specification Description     |
-     | -     | -     | Use the following procedure in order to determine the actual camshaft lobe lift: 1. Measure camshaft lobe height (B). 2. Measure base circle (C). 3. Subtract the base circle (C) from the camshaft lobe height (B), the difference is the actual camshaft lobe lift.     |
A     | -     | -     | Specified camshaft lobe lift for Inlet lobe is 9.431 mm (0.3713 inch). Injector lobe 10.370 mm (0.4082 inch). Exhaust lobe 8.515 mm (0.3352 inch).     |
Caterpillar Information System:
C7.1 Industrial Engine Diagnostic Flash Code Retrieval
C18 Marine Propulsion Engines Piston and Rings
C32 Marine Engines Exhaust Manifold - Water cooled
C7.1 Marine Engine Exhaust Manifold - Remove and Install
C7.1 Marine Engine Inlet Manifold - Remove and Install
C175-16 Locomotive Engine Coolant Temperature Is High
C280-16 Engine Safety Messages
2013/02/11 Updating the Fuel Filter Group on Certain C27 and C32 Industrial Engines {1261, 1262}
NOx Sensors Handling and Installation Procedures {191N} NOx Sensors Handling and Installation Procedures {191N}
C280-16 Engine Model View Illustrations
C27 Generator Set Safety Messages
CG137 Engines Crank But Do Not Start{1000} CG137 Engines Crank But Do Not Start{1000}
C32 Marine Engines Electric Starting Motor
C18 Marine Propulsion Engines Cylinder Head Valves
C9.3 Head Tool Improvements{0599, 0701, 0703, 1100} C9.3 Head Tool Improvements{0599, 0701, 0703, 1100}
C7.1 Engines for Caterpillar Built Machines Piston and Rings
C9.3 Engines for Caterpillar Built Machines Diesel Particulate Filter - Remove and Install
2013/02/08 A New Turbocharger Group Is Available for Certain C15 Truck Engines {1052, 1053}
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Fuel Pressure Problem - Gas System
2013/02/22 Bearing Upgrade from Pre 2.4 or 2.4 Bearings to 3.5 Bearing on Certain Uninterruptible Power Supply {4480, 7551}
C18 Marine and Marine Generator Set Engines Auxiliary Water Pump - Sea Water
C7.1 Engines for Caterpillar Built Machines Speed/Timing Sensor
C18 Marine Propulsion Engines Auxiliary Water Pump - Sea Water
C7.1 Engines for Caterpillar Built Machines Engine Oil Pump