Aftercooler - Remove and Install - G3408B
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件描述     | 数量     |
A     | 207-1600 (1)     | 橡胶润滑剂     | 1     |
207-1601 | 橡胶润滑剂     | 1     |
Show/hide table
( 1 ) | 用于 EAME |
开始:
- 拆下空燃混合器。
- 有关正确的排放和加注步骤,请参阅操作和保养手册, "冷却液 - 更换"。
- 拆下支架 (1) 。 必要时,将管组件 (3 ) 放置在一侧。
Show/hide table
图 1 | g03323356 |
- 拆下夹子 (5) 。
- 卸下螺栓 (4) 。 拆下适配器 (6) 和 O 形密封圈。
- 拆下螺栓 (7) 和盖 (2) 。 必要时,检查并更换密封垫。
- 拆下螺栓 (9) 并将适当的起吊设备连接到后冷器 (8) 上的位置 (X) 。 后冷器 (8) 的重量约为 30 kg (65 lb)。
Show/hide table
图 2 | g03323380 |
- 拆下后冷器 (8) 。 必要时,拆下壳体 (10) 。
- 将 O 形密封圈 (11) 从后冷器 (8) 上拆下。
Show/hide table
图 3 | g03323550 |
安装步骤
- 按与拆卸相反的顺序安装后冷器 (8) 。
- 将工具 (A) 涂覆到 O 形密封圈 (11) 和孔上。
Caterpillar Information System:
CG137-08 and CG137-12 Engines Rotary Actuator (Carburetor) - Remove and Install - G3408B
3512B and 3512C Petroleum Generator Set Engines Direct Fuel Control Mode - Test
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Fuel Actuator - Test
3516C Locomotive Engines Selective Catalytic Reduction System Monitoring
Release Notes for VisionLink and VisionLink Store for All Caterpillar Products {7606, 7620} Release Notes for VisionLink and VisionLink Store for All Caterpillar Products {7606, 7620}
C15 and C18 Engines Welding on Engines with Electronic Controls
C1.5 and C2.2 Engines for Caterpillar Built Machines ECM Harness Connector Terminals
C175-16 Locomotive Engine Air Lines - Aftercooler
C1.5 and C2.2 Industrial Engines Idle Validation Switch Circuit - Test
C175-16 Locomotive Engine Air Lines - Aftercooler
2013/03/21 New Water Ferrules Are Available for 3500 Engine Cylinder Heads {1124, 7555}
794 AC Off-Highway Truck Engine Starting
421-9723 Top End Engine Overhaul Foundational Kit for 3412C Marine Engines{1000} 421-9723 Top End Engine Overhaul Foundational Kit for 3412C Marine Engines{1000}
421-9725 Top End Engine Overhaul Foundational Kit for 3412E Marine Engines{1000} 421-9725 Top End Engine Overhaul Foundational Kit for 3412E Marine Engines{1000}
3516B Engine Fuel Injector - Check
G3500 A3 Engines Air/Fuel Ratio Control - Adjust - NO<SUB>X</SUB> Feedback
CG137-08 and CG137-12 Engines Turbocharger - Remove and Install - G3408B
3512B, 3512C, and 3516B Petroleum Engines and Petroleum Generator Set Engines with Dynamic Gas Blending Fuel Shutoff - Test
2013/06/19 An Improved Air Conditioner Condenser Fan Motor is Available for Certain Excavators {1805}
3516B Engine Water Temperature Regulators - Remove
3516B Engine Overhaul (Top End)
Inspection and Cleaning Procedure For Certain Uninterruptible Power Supplies{4480} Inspection and Cleaning Procedure For Certain Uninterruptible Power Supplies{4480}
C175-16 Locomotive Engine Engine Oil Pan
C1.5 and C2.2 Industrial Engines Solenoid Valve - Test