Camshaft Bearing Position
Show/hide table
| |
| Illustration 1 | g03061736 |
|
Right side view | |
Show/hide table
| Specification for 240-6650 Cylinder Block Gp and 373-2260 Cylinder Block Gp | |||
| Item | Qty | Part | Specification Description |
| The camshaft bearings from the rear surface of the cylinder block are the following dimensions: | |||
| The oil holes must be aligned at the correct angle when the bearings are installed. Refer to Specifications, "Cylinder Block" for the correct angle. | |||
| A | - | - | Distance from rear face of cylinder block is |
| B | - | - | Distance from rear face of cylinder block is |
| C | - | - | Distance from rear face of cylinder block is |
| D | - | - | Distance from rear face of cylinder block is |
| E | - | - | Distance from rear face of cylinder block is |
| F | - | - | Distance from rear face of cylinder block is |
| G | - | - | Distance from rear face of cylinder block is |
Caterpillar Information System:
3500 Industrial Engines Aftercooler
C3.3B and C3.8 Engines for Caterpillar Built Machines Coolant Level Is Low
C3.3B and C3.8 Engines for Caterpillar Built Machines Coolant Contains Oil
C3.3B and C3.8 Engines for Caterpillar Built Machines Acceleration Is Poor or Throttle Response Is Poor
C3.3B and C3.8 Engines for Caterpillar Built Machines Electronic Service Tools
C3.3B and C3.8 Engines for Caterpillar Built Machines Test ECM Mode
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM - Replace
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM Software - Install
2012/09/11 Improved VisionLinkTM Software Is Now Available for Certain Caterpillar Machines {7601}
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System - Prime
C1.5 and C2.2 Engines for Caterpillar Built Machines Cylinder Head - Inspect
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System
G3516C and G3516E Gas Engines Cylinder Head
C1.5 and C2.2 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (Earlier) - Replace
C18 Marine Engines Air Cleaner - Remove and Install
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace
UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Serial Number Plate
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System - Inspect
C1.5 and C2.2 Engines for Caterpillar Built Machines Air Inlet and Exhaust System
C18 Marine Engines Exhaust Manifold - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines Electronic Control System Components
2013/03/15 New Jacket Water Heater System Components Are Used on Certain C27, C32, 3500, and C175 Generator Set Engines {1383}