Cylinder Head - Inspect
Show/hide table
| Required Tools | ||
|---|---|---|
| Part Number | Part Name | Qty |
| 8S-6691 | Cylinder Head Stand Set | 1 |
Show/hide table
| |
| Illustration 1 | g00907442 |
|
Bolt tightening sequence for the C1.5 engines | |
Show/hide table
| |
| Illustration 2 | g00907444 |
|
Bolt tightening sequence for the C2.2 engine | |
- Remove the bolts in the cylinder head in the reverse sequence that is shown in Illustrations 1 and 2.
Remove the cylinder head from the engine.
- Clean the cylinder head thoroughly. Make sure that the contact surface of the cylinder head and the contact surface of the cylinder block are clean, smooth, and flat.
- Inspect the bottom surface of the cylinder head for pitting, corrosion, and cracks. Inspect the area around the valve seats and the holes for the fuel injection nozzles.
Show/hide table
Illustration 3 g00842292 Typical example - Put cylinder head (1) on the 8S-6691 Cylinder Head Stand Set (2).
Show/hide table
Illustration 4 g00907448 Typical example - Use a straight edge and a feeler gauge to check the six positions of the cylinder head for distortion. Refer to Specifications, "Cylinder Head" for the requirements of flatness.
Caterpillar Information System:
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
G3500B Engines Gear Group (Front)
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
C1.5 and C2.2 Engines for Caterpillar Built Machines Basic Engine
C1.5 and C2.2 Engines for Caterpillar Built Machines Cooling System
C1.5 and C2.2 Engines for Caterpillar Built Machines General Information
G3516C and G3516E Gas Engines Engine Oil Filter
3500B Locomotive Engines Auxiliary Drive (Lower Left Hand)
G3516C and G3516E Gas Engines Water Lines
LEM Failures On UPSB505 Uninterruptible Power Supply{4480} LEM Failures On UPSB505 Uninterruptible Power Supply{4480}
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (3.5 EVD or Greater) - Replace
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (Earlier) - Replace
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System - Prime
2012/09/11 Improved VisionLinkTM Software Is Now Available for Certain Caterpillar Machines {7601}
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM Software - Install
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM - Replace
C3.3B and C3.8 Engines for Caterpillar Built Machines Test ECM Mode
C3.3B and C3.8 Engines for Caterpillar Built Machines Electronic Service Tools
C3.3B and C3.8 Engines for Caterpillar Built Machines Acceleration Is Poor or Throttle Response Is Poor
C3.3B and C3.8 Engines for Caterpillar Built Machines Coolant Contains Oil
C3.3B and C3.8 Engines for Caterpillar Built Machines Coolant Level Is Low
3500 Industrial Engines Aftercooler
3500 Marine Engines Camshaft Bearing Position
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System