Note: If a fuel injection pump is removed, replace the old shims with new shims of the same thickness. Old shims must not be reused.
Note: If the thickness of the shim is
Note: If there are three shims installed, the non-beaded shim is always installed on the inside. If only one or two shims are installed, all shims are beaded.
On C1.5 engines, select the correct combination of shims from table 1.
Shim Thickness (mm) | Part Number | Beaded |
0.2 | 236-4961 | Yes |
0.25 | 311-1168 | Yes |
0.3 | 236-4959 | Yes |
0.35 | 311-1169 | Yes |
0.4 | 236-4954 | Yes |
0.5 | 236-4952 | Yes |
0.5 | 160-7034 | No |
On C2.2 engines, select the correct combination of shims from table 2.
Shim Thickness (mm) | Part Number | Beaded |
0.2 | 351-2622 | Yes |
0.25 | 351-2617 | Yes |
0.3 | 351-2621 | Yes |
0.35 | 351-3132 | Yes |
0.4 | 351-2620 | Yes |
0.5 | 351-2619 | Yes |
0.5 | 351-2618 | No |
If the original shim thickness cannot be determined, contact the Dealer Solution Network. The user must provide the full engine number of the product that is serviced.