Engine Oil Filter
Show/hide table
| |
| Illustration 1 | g03058037 |
|
Right side view of engine | |
Show/hide table
| Specification for 360-4240 | |||
| Item | Qty | Part | Specification Description |
| 1 | 2 | 6B-9202 Spring | Length under test force is Test force is Free length after test is |
| 2 | 2 | 7N-7697 Plunger | Cooling jet sequence valves must start to open at a pressure difference of Cooling jet sequence valves must be fully open at a pressure difference of |
| 3 | 3 | 275-2604 Engine Oil Filter | Screw the filter element onto the mounting base until the sealing surface contacts the base. Then tighten the filter element for an additional one full turn. |
| 4 | 3 | 109-2332 O-Ring Seal | Before assembly, lubricate the bore lightly with the lubricant that is being sealed. |
| 5 | 1 | 228-7097 O-Ring Seal | Before assembly, lubricate the bore lightly with the lubricant that is being sealed. |
| 6 | 3 | 7G-6713 Spring | Length under test force is Test force is Free length after test is |
| 7 | 3 | 1P-1367 Plunger | Bypass valve must start to open at a pressure difference of The plunger must move freely in the bore. |
| 8 | 2 | 0S-1594 Bolt | Torque to |
| 9 | 2 | 0S-1571 Bolt | Torque to |
Show/hide table
| |
| Illustration 2 | g03058038 |
|
front view of engine | |
Show/hide table
| Item | Qty | Part | Specification Description |
| 10 | 1 | 6V-4589 O-Ring Seal | Before assembly, lubricate the bore lightly with the lubricant that is being sealed. |
Caterpillar Information System:
3500B Locomotive Engines Auxiliary Drive (Lower Left Hand)
G3516C and G3516E Gas Engines Water Lines
LEM Failures On UPSB505 Uninterruptible Power Supply{4480} LEM Failures On UPSB505 Uninterruptible Power Supply{4480}
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (3.5 EVD or Greater) - Replace
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Bearing (Earlier) - Replace
UPS 1000S and UPS 1200S Uninterruptible Power Supplys , Parallel Maintenance Interval Schedule
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace
UPS 120, UPS 150, UPS 250 and UPS 300 Uninterruptible Power Supplies Bearing (Earlier) - Replace
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (3.5 EVD or Greater) - Replace
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Bearing (Earlier) - Replace
C7.1-XQ200 Rental Generator Set Diesel Particulate Filter Regeneration
C18 Marine Engines Fuel Filter Base - Remove and Install
C1.5 and C2.2 Engines for Caterpillar Built Machines General Information
C1.5 and C2.2 Engines for Caterpillar Built Machines Cooling System
C1.5 and C2.2 Engines for Caterpillar Built Machines Basic Engine
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Injection Timing - Check
G3500B Engines Gear Group (Front)
C1.5 and C2.2 Engines for Caterpillar Built Machines Engine Valve Lash - Inspect/Adjust
C1.5 and C2.2 Engines for Caterpillar Built Machines Cylinder Head - Inspect
C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel System - Prime
2012/09/11 Improved VisionLinkTM Software Is Now Available for Certain Caterpillar Machines {7601}
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM Software - Install
C3.3B and C3.8 Engines for Caterpillar Built Machines ECM - Replace
C3.3B and C3.8 Engines for Caterpillar Built Machines Test ECM Mode