Engine Has Mechanical Noise (Knock)
- 隔离噪音源。
- 配气机构部件
- 活塞
- 曲轴
- 齿轮系
Show/hide table
故障诊断与排除测试步骤 | 数值 | 结果 |
---|---|---|
1. 隔离噪音源 A. 如果噪音源为发动机附件,则拆下可疑的发动机附件。 检查可疑的发动机附件。 |
发动机附件 |
结果 发动机附件不是噪音源。 修理:转至下一步骤 结果 发动机附件是噪音源。 修理:如有必要,修理和/或更换发动机附件。 如果故障未得到排除,转至下一步骤。 |
2. 检查配气机构部件 A. 拆下气门机构盖和凸轮轴盖。 B. 检查以下部件有无损坏: - 凸轮轴 - 气门弹簧 - 挺杆 - 推杆 - 气门桥 C. 有关更多信息,参考拆解和装配。 D. 彻底清洁配气机构部件。 确保所有气门都能自由运动。 更换所有损坏的零件。 E. 发动机以额定转速操作时,可观察和测量气门旋转。 |
配气机构 |
结果:配气机构部件未损坏。 修理:转至下一步骤。 转至下一测试步骤 结果:配气机构部件损坏。 修理:如有必要,修理和/或更换发动机部件。 如果故障未排除,转至下一测试步骤。 |
3. 检查活塞有无损坏和磨损。 |
活塞 |
结果:活塞正常。 修理:转至下一测试步骤 结果:活塞不正常。 修理:执行必要的修理或更换。 如果故障未得到排除,转至下一步骤。 |
4. 检查曲轴 A. 检查曲轴和相关部件。 查找止推片和曲轴有无磨损。 B. 检查曲轴上的连杆轴承和轴承表面。 确保轴承处于正确位置。 C. 检查配重螺栓。 |
曲轴 |
结果:曲轴或相关部件损坏或磨损。 修理:修理或更换任何损坏零件。 确认修理后故障得到排除。 如果故障未排除,转至下一测试步骤。 |
5. 检查齿轮系 A. 检查齿轮系和下端部件。 |
齿轮系 |
结果:齿轮系正常。 结果:齿轮系不正常。 修理:修理或更换任何损坏零件。 确认修理后故障得到排除。 |
Caterpillar Information System:
C175-16 Locomotive Engine Fuel Temperature Is High
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Speed Control
C280 Marine, Marine Auxiliary, and Petroleum Engines Metal Particle Detector - Inspect/Clean
C280 Marine, Marine Auxiliary, and Petroleum Engines Exhaust Piping - Check
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Valve Lash and Bridge - Check
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Air Precleaner - Check/Clean
C280 Marine, Marine Auxiliary, and Petroleum Engines Engine Air Cleaner Element (Single Element) - Inspect/Replace
C15 Petroleum Generator Set Engines Engine Valve Lash - Inspect/Adjust
C280 Marine, Marine Auxiliary, and Petroleum Engines Coolant Sample (Level 1) - Obtain
C280 Marine, Marine Auxiliary, and Petroleum Engines Coolant Level - Check
3516B Generator Set Engines with Dynamic Gas Blending ECM - Replace
C280 Marine, Marine Auxiliary, and Petroleum Engines Coolant (ELC) - Change
TH48-E80 Petroleum Transmission Torque Converter and Transmission Oil Sample - Obtain
2012/09/13 New Basic Engine Components Are Used in C175-16 Engines {1156, 1202, 1205, 1218}
C175-16 Marine Propulsion Engines Engine Harness
C175-16 Marine Propulsion Engines Exhaust Temperature Is Low
C175-16 Locomotive Engine Aftercooler Coolant Temperature Is High
C175-16 Marine Propulsion Engines Engine Misfires, Runs Rough or Is Unstable
3500E Marine Engines Coolant Temperature Regulator - Replace
2012/05/04 New Software Is Available for Certain C18 Industrial Engines {1901, 1920}
Repair of Exhaust Shields on Certain C13 and C15 Engines{1059, 1067} Repair of Exhaust Shields on Certain C13 and C15 Engines{1059, 1067}
2012/03/21 New Engine Software Is Now Available for Certain C32 Generator Sets {1920}
Improper Orientation of the 8S-5383 Block Used in the Alternator Mounting Group of Certain Marine Engines{1154, 1405, 1405} Improper Orientation of the 8S-5383 Block Used in the Alternator Mounting Group of Certain Marine Engines{1154, 1405, 1405}
Guideline for Proper Gasket Handling and Installation {0599, 0648, 0681, 1000, 7555} Guideline for Proper Gasket Handling and Installation {0599, 0648, 0681, 1000, 7555}