C175-16 Marine Engine Caterpillar

Removal Procedure

Start By:

1. Remove the air shutoff.

Show/hide table

Illustration 1	g02019315

1. Remove bolts (2) from cover (1) for the harness assembly. Position cover (1) for the harness assembly out of the way. Ensure support for the harness in order to prevent damage.
   Show/hide table

   Illustration 2	g01242582

2. Attach a suitable lifting device onto air inlet manifold (6). The weight of air inlet manifold (6) is approximately 48 kg (105 lb). Remove bolt (3). Remove bolts (4) and bolts (5).

3. Remove air inlet manifold (6).

4. Repeat the procedure on the opposite side.

Installation Procedure

1. Install air inlet manifold (6) in the reverse order of removal.

   Note: When elbow (9), the connector, and elbow (10) are connected, ensure that there is 1mm spacing between each of the elbows and the connector.

   Note: When air inlet manifold (6) is installed. Ensure that there is 3mm clearance between air inlet manifold (6) and the tubes coming out of the aftercooler. The clearance between air inlet manifold (6) and the tubes coming out of the aftercooler are in order to prevent rubbing.

End By:

1. Install the air shutoff.