Diesel Particulate Filter Temperature and Pressure Sensor
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Bostik Pure Nickel Anti-Seize Compound |
1 |
Show/hide table
Illustration 1 | g02154926 |
Typical example |
Note: Use tooling (A) in order to lubricate the thread of temperature sensor (1).
(1) Tighten the temperature sensors to the following torque. ...
Show/hide table
Illustration 2 | g02291853 |
Typical example |
(3) Tighten allen head bolt to the following torque. ...
(2) Tighten bolt (not shown) to the following torque. ...
(1) Tighten bolt to the following torque. ...
Caterpillar Information System:
C6.6 Industrial Engine Fuel Transfer Pump - Electric Transfer Pump
C7.1 Engines for Caterpillar Built Machines Belt Tensioner
C3.4B Engines Valve Lash Is Excessive
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C3.4B Engines Oil Pressure Is Low
C3.4B Engines Oil Contains Coolant
C3.4B Engines Oil Consumption Is Excessive
C27 and C32 Industrial Engines Inlet Manifold - Remove and Install
C27 and C32 Industrial Engines Cylinder Head - Install
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Control (Pedal) - Calibrate
2010/10/08 Using the Detonation Detection System to Troubleshoot Mechanical Problems in G3600 Engines {1223, 1559}
140 Motor Grader Engine Air Filter Secondary Element - Replace
C7.1 Industrial Engine Diesel Particulate Filter
C9.3 Tier 4 Final Engines Electric Starting Motor
C7.1 Industrial Engine Starting the Engine
C6.6 Industrial Engine Fuel Manifold (Rail)
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System One-Way/One or Two Pump - Electric Control: Relief Valve (Line) - Test and Adjust - Tool Relief Valve
C13, C15, and C18 Tier 4 Final Engines Fuel Pressure Regulator
G3520E Generator Set Engines Configuration Parameters
2010/10/20 A New Rocker Shaft Bolt Is Used on Certain C15 and C18 Engines {1102, 7553}
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Main) - Test and Adjust
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Line) - Test and Adjust
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump and Primary Fuel Filter - With Water Separator
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System System Identification