Fuel Manifold (Rail)
Refer to Operation and Maintenance Manual, "General Hazard Information and High Pressure Fuel Lines" before adjustments and repairs are performed.
Show/hide table
| NOTICE |
|---|
|
Refer to Systems Operation, Testing and Adjusting, "Cleanliness of Fuel System Components" for detailed information on the standards of cleanliness that must be observed during ALL work on the fuel system. |
Show/hide table
| |
| Illustration 1 | g02293653 |
|
Typical example | |
(1) Tighten the bolts to the following torque. ...
(2) Tighten the bolts to the following torque. ...
(3) Tighten the fuel pressure relief valve to the following torque. ...
Note: The fuel pressure relief valve (3) should be tightened an additional 24 degrees.
Caterpillar Information System:
C7.1 Industrial Engine Starting the Engine
C9.3 Tier 4 Final Engines Electric Starting Motor
C7.1 Industrial Engine Diesel Particulate Filter
C7.1 Industrial Engine Diesel Particulate Filter Temperature and Pressure Sensor
C6.6 Industrial Engine Fuel Transfer Pump - Electric Transfer Pump
C7.1 Engines for Caterpillar Built Machines Belt Tensioner
C3.4B Engines Valve Lash Is Excessive
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C3.4B Engines Oil Pressure Is Low
C3.4B Engines Oil Contains Coolant
C3.4B Engines Oil Consumption Is Excessive
C27 and C32 Industrial Engines Inlet Manifold - Remove and Install
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System One-Way/One or Two Pump - Electric Control: Relief Valve (Line) - Test and Adjust - Tool Relief Valve
C13, C15, and C18 Tier 4 Final Engines Fuel Pressure Regulator
G3520E Generator Set Engines Configuration Parameters
2010/10/20 A New Rocker Shaft Bolt Is Used on Certain C15 and C18 Engines {1102, 7553}
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Main) - Test and Adjust
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Line) - Test and Adjust
C15 and C18 Engines for Caterpillar Built Machines Fuel Priming Pump and Primary Fuel Filter - With Water Separator
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System System Identification
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Work Tool - Select
349F and 352F Excavators Hydraulic System Work Tool Parameter - Program
C15 and C18 Engines Safety Messages
2010/11/29 Retrofitting for Ultra Lean Burn on a G3516 Engine {1000, 775E}