C7.1 Engines for Caterpillar Built Machines Caterpillar


Belt Tensioner

Usage:

525D 2L5


Illustration 1g02291813
Typical example

(1) Tighten the bolt to the following torque. ... 45 N·m (33 lb ft)

Note: To install the belt tensioner, refer to Disassembly and Assembly, "Belt Tensioner - Remove and Install" for the correct procedure.

Caterpillar Information System:

C3.4B Engines Valve Lash Is Excessive
C3.4B Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C3.4B Engines Oil Pressure Is Low
C3.4B Engines Oil Contains Coolant
C3.4B Engines Oil Consumption Is Excessive
C27 and C32 Industrial Engines Inlet Manifold - Remove and Install
C27 and C32 Industrial Engines Cylinder Head - Install
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Control (Pedal) - Calibrate
2010/10/08 Using the Detonation Detection System to Troubleshoot Mechanical Problems in G3600 Engines {1223, 1559}
140 Motor Grader Engine Air Filter Secondary Element - Replace
C9.3 Industrial Engine Valve Mechanism Cover
C3.4B Engines Fuel Contains Water
C6.6 Industrial Engine Fuel Transfer Pump - Electric Transfer Pump
C7.1 Industrial Engine Diesel Particulate Filter Temperature and Pressure Sensor
C7.1 Industrial Engine Diesel Particulate Filter
C9.3 Tier 4 Final Engines Electric Starting Motor
C7.1 Industrial Engine Starting the Engine
C6.6 Industrial Engine Fuel Manifold (Rail)
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System One-Way/One or Two Pump - Electric Control: Relief Valve (Line) - Test and Adjust - Tool Relief Valve
C13, C15, and C18 Tier 4 Final Engines Fuel Pressure Regulator
G3520E Generator Set Engines Configuration Parameters
2010/10/20 A New Rocker Shaft Bolt Is Used on Certain C15 and C18 Engines {1102, 7553}
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Main) - Test and Adjust
349E, 349F and 352F Excavators and 349E MHPU Mobile Hydraulic Power Unit Tool Control System Medium Pressure: Relief Valve (Line) - Test and Adjust
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.