Air Starting Motor - Lubricate
空气起动马达一定要使用润滑器。 确保润滑器油杯中润滑油油位至少半满。
温度高于 0 °C (32 °F) 时,使用不带清洁剂的 SAE 10W 马达油。
温度低于 0 C (32 °F) 时,使用空气工具用油。
为保持起动马达的效率,应定期冲刷起动马达。 将大约 0.5 L (0.50 qt) 的正确的润滑剂加到起动马达的进气口内,运转马达。 润滑剂将清除马达叶片上的污物、废油和水。
Caterpillar Information System:
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Replaced Relay or Solenoid Does Not Operate
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Transmission Does Not Automatically Shift Back Into Gear
G3304B and G3306B Engines Unburned Gas - Purge
G3304B and G3306B Engines Gas Pressure Regulator - Remove
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Transmission Does Not Automatically Shift Into Neutral
C9.3 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install
G3304B and G3306B Engines Engine Support - Remove and Install
2009/06/08 Improved Hardware Is Used on the Sealing Joint between the Turbocharger and the Exhaust Manifold on Certain 3512B Marine Engines {1052, 1053}
Procedure to Route the Hose for the Jacket Water Around the Alternator Bracket{1380, 1383} Procedure to Route the Hose for the Jacket Water Around the Alternator Bracket{1380, 1383}
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 1428 - FMI 03
G3304B and G3306B Engines Radiator Group - Install
C9 Marine Engines Drive Shaft Slip Joint - Lubricate - If Equipped with a Pod Drive Unit
G3304B and G3306B Engines Starting Air Pressure - Adjust
G3304B and G3306B Engines Gas Pressure Regulator - Disassemble
G3304B and G3306B Engines Gas Pressure Regulator - Assemble
C11 and C13 Engines Cylinder Head Valves
C13 Engine for Combat and Tactical Vehicles Air Lines
G3304B and G3306B Engines Gas Pressure Regulator - Install
C18 Marine Engine Plate Locations and Film Locations
C11 and C13 Engines Engine Oil Pump
G3304B and G3306B Engines Carburetor - Remove
C9.3 Engines for Caterpillar Built Machines Fuel Lines - Remove and Install
2009/06/01 Guidelines for Reusability of Cylinder Head Studs, Main Bearing Cap Studs, Main Bearing Cap Cross Tie Bolts, and Connecting Rod Cap Bolts and Nuts {1100, 1218, 1230}
G3304B and G3306B Engines Spark Plug - Test