Transmission Does Not Automatically Shift Back Into Gear
因快速切换到空档、锁定到空档或停车制动器空档功能可能故障,变速箱无法换入某个档位。 这些功能可能包括以下编程:
- 空档器开关安装 - 已安装
- 锁定到空档开关安装 - 已安装
- 停车制动器空档操作 - 已启用
正常操作 - 当快速切换到空档(空档器)开关关闭(闭合)时,锁定到空档开关关闭(闭合),停车制动器关闭,变速箱可换到空档。
检查下列各项:
- 通过观察 Caterpillar 电子技师(Cat ET)中的空档器开关状态,检查确认快速切换到空档开关闭合,功能停止。
- 通过观察 Cat ET 中的变速箱锁定状态,检查确认锁定到空档开关闭合,功能停止。
- 通过观察 Cat ET 中的停车制动器状态,检查确认停车制动器开关关闭。
Caterpillar Information System:
G3304B and G3306B Engines Unburned Gas - Purge
G3304B and G3306B Engines Gas Pressure Regulator - Remove
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Transmission Does Not Automatically Shift Into Neutral
C9.3 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install
G3304B and G3306B Engines Engine Support - Remove and Install
2009/06/08 Improved Hardware Is Used on the Sealing Joint between the Turbocharger and the Exhaust Manifold on Certain 3512B Marine Engines {1052, 1053}
Procedure to Route the Hose for the Jacket Water Around the Alternator Bracket{1380, 1383} Procedure to Route the Hose for the Jacket Water Around the Alternator Bracket{1380, 1383}
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 1428 - FMI 03
G3304B and G3306B Engines Radiator Group - Install
C9 Marine Engines Drive Shaft Slip Joint - Lubricate - If Equipped with a Pod Drive Unit
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Connector Locations
G3304B and G3306B Engines ECM Will Not Accept Factory Passwords
CX35-P800-C18I and CX35-P800-C27I Petroleum Power Train Packages and CX35-P800 Petroleum Transmission Replaced Relay or Solenoid Does Not Operate
G3304B and G3306B Engines Air Starting Motor - Lubricate
G3304B and G3306B Engines Starting Air Pressure - Adjust
G3304B and G3306B Engines Gas Pressure Regulator - Disassemble
G3304B and G3306B Engines Gas Pressure Regulator - Assemble
C11 and C13 Engines Cylinder Head Valves
C13 Engine for Combat and Tactical Vehicles Air Lines
G3304B and G3306B Engines Gas Pressure Regulator - Install
C18 Marine Engine Plate Locations and Film Locations
C11 and C13 Engines Engine Oil Pump
G3304B and G3306B Engines Carburetor - Remove
C9.3 Engines for Caterpillar Built Machines Fuel Lines - Remove and Install