Fumes Disposal Filter Element - Replace - Heavy Duty Closed Crankcase Ventilation Fumes Disposal Filter (If Equipped)
重载闭式曲轴箱通风系统(HDCCV)需要更换烟雾处理滤清器。 烟雾处理系统的使用周期将会受下列各项的影响:
- 发动机负载
- 烟灰浓度
- 发动机状况
Show/hide table
热油和热的部件可能会导致人员受伤。 不要让热的油和部件接触皮肤。 |
注: 可能的话,在关闭发动机的同时进行保养。
- 松开将碳罐固定在滤清器座组件上的卡销。
注: 发动机运转过程中可能很难拆卸碳罐。 发动机运转过程中碳罐有负气压。 这会产生真空度。
- 降下碳罐,以便露出滤芯。 碳罐底部可能会有机油。 避免机油溅出。
- 向下拉滤芯,卸下滤芯。 妥善处理旧滤芯。
- 卸下旧滤芯顶端盖上的 O 形密封圈组件。 妥善处理 O 形密封圈组件。 用新 O 形密封圈组件更换旧 O 形密封圈组件。
- 卸下旧滤芯底端盖上的 O 形密封圈组件。 妥善处理 O 形密封圈组件。 用新 O 形密封圈组件更换旧 O 形密封圈组件。
- 将滤芯安装到正确的位置。
- 更换碳罐,对准碳罐与滤清器座组件上的凸台。
- 将卡销夹紧在闭合位置。
Show/hide table
图 1 | g01886842 |
典型安装 (1) 滤清器座组件 (2) 锁扣 (3) 滤罐 |
Show/hide table
注意 |
---|
在检查、保养、测试、调整及维修产品时,请小心确保盛接油液。 在打开任何舱室或拆卸任何含有油液的部件前,请准备好盛接液体用的适当容器。 有关适于收集和盛放 Cat 产品油液的工具和用品,请参阅专门出版物, NENG2500, "Cat 代理商维修工具目录"或专门出版物, PECJ0003, "Cat 车间用品和工具目录"。 按照本地法规和要求处置所有油液。 |
Caterpillar Information System:
C15 and C18 Industrial Engines Catalyst - Remove and Install - Diesel Oxidation Catalyst, Clean Emissions Module
C7.1 Industrial Engine and Generator Set Electrical Connectors - Inspect
C13 Engine Electronic Unit Injector Sleeve - Install
C13 Engine Electronic Unit Injector Sleeve - Remove
C13 Engine Electronic Unit Injector - Install
C13 Engine Electronic Unit Injector - Remove
C13 Engine Fuel Transfer Pump - Install
C13 Engine Fuel Transfer Pump - Remove
C13, C15, and C18 Tier 4 Interim Engines ARD Nozzle - Test
C7.1 Industrial Engine Engine Crankcase Breather Element - Replace
C13 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install - Differential Pressure Sensor
C13 Engines for Caterpillar Built Machines Pressure Sensor (Cooled Exhaust Gas) - Remove and Install
An Improved Filter Element for the Power Train has Been Released{3067, 5068} An Improved Filter Element for the Power Train has Been Released{3067, 5068}
C9 On-highway Engine Diesel Particulate Filter
G3516 Power Module Crankcase Pressure - Measure - Engines with Fumes Disposal Filters
Cat Commercial Diesel Engine Fluids Recommendations Biodiesel
2009/04/20 A New Connector Assembly and Hose Assembly are Now Used on Certain Caterpillar Products {5079, 5117}
PM3516 Power Modules Fumes Disposal Filter Element - Replace
C9 On-highway Engine Diesel Particulate Filter Temperature and Pressure Sensor
C13 Engine Inlet and Exhaust Valve Springs - Remove and Install
C13 Engine Inlet and Exhaust Valves - Remove and Install
C13 Engine Inlet and Exhaust Valve Guides - Remove and Install
C13 Engine Inlet and Exhaust Valve Seat Inserts - Remove and Install
C13 Engine Engine Oil Filter Base - Remove