Electric Starting Motor - Remove and Install
- Disconnect the cable assemblies from solenoid (1) and electric starting motor (2).
If the engine has two electric starting motors, disconnect the cable assemblies between the two solenoids and the electric starting motors.
- Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately
30 kg (66 lb) . - Remove three bolts (3). Remove electric starting motor (2). Remove the gasket from the joint between electric starting motor (2) and the flywheel housing.
Show/hide table
Disconnect batteries before performance of any service work. |
Note: Before disconnecting the cable assemblies, mark the items for the proper connections in order to ensure correct assembly.
Show/hide table
Illustration 1 | g00597378 |
- Inspect the gasket for the joint between the electric starting motor and the flywheel housing. Obtain a new gasket, if necessary.
Show/hide table
Illustration 2 g00597378 - Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately
30 kg (66 lb) . - Place the gasket in the cover for electric starting motor (2). Position the gasket on the flywheel housing. Lift electric starting motor (2) onto the mounting position. Install three bolts (3).
- Connect the cable assemblies to solenoid (1) and electric starting motor (2).
If the engine has two electric starting motors, connect the cable assemblies between the two solenoids and the electric starting motors.
Caterpillar Information System:
G3500B Engines Sensor Signal (Analog, Active) - Test
G3500B Engines Indicator Lamp - Test
345D, 349D and 349D2 Excavators and 345D MHPU and 349D MHPU Mobile Hydraulic Power Units Machine Systems Main Control Valve - Install
C6.6 Marine Generator Set Cooling System - Inspect
G3500B Engines Ignition Secondary - Test
C6.6 Marine Generator Set Alternator - Test
2008/12/29 A New Coolant Hose Is Used {1380, 1383}
C6.6 Marine Generator Set Glow Plugs - Test
G3500B Engines Ignition Primary - Test
2008/12/22 New PL1000E Software is Now Available {7610}
Compatible Puller Stud and Hydraulic Cylinder Capacity Chart {0599, 7000, 7562} Compatible Puller Stud and Hydraulic Cylinder Capacity Chart {0599, 7000, 7562}
793F and 797F Off-Highway Trucks Chassis Electronic Control System MID 087 - CID 2851 - FMI 06
G3516 Petroleum Engines Air Starting Motor - Disassemble
G3516 Petroleum Engines Air Starting Motor - Assemble
2009/02/01 A New Turbocharger Oil Line Is Used on C15 Truck Engines {1052, 1307}
2011/05/04 A New Coil Assembly is Now Used {5479}
793F Off-Highway Truck Braking
CX31-P600 Petroleum Transmission Relief Valve (Transmission Oil Filter Bypass)
CX31-P600 Petroleum Transmission Pressure Switch (Transmission Oil Filter Bypass)
Cat Commercial Diesel Engine Fluids Recommendations Lubricant Information
C6.6 Marine Generator Set CID 0268 FMI 02
G3500B Engines Sensor Signal (Analog, Passive) - Test
G3500B Engines Sensor Signal (PWM) - Test
G3500B Engines Sensor Supply - Test