Jacket Water Heater - Remove and Install
Removal Procedure
- Ensure that all electrical power for the jacket water heater is turned to the OFF position.
- Drain the coolant from the cooling system into a suitable container for storage or for disposal. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
- Disconnect hoses (1) and disconnect the harness assembly that connects to the thermostat assembly (not shown).
Show/hide table
Illustration 1 | g01789140 |
- Remove clamp assemblies (2) and remove jacket water heater (3) .
Installation Procedure
- Position jacket water heater (3) and install clamp assemblies (2) .
Show/hide table
Illustration 2 | g01789140 |
- Connect hoses (1) and connect the harness assembly that connects to the thermostat assembly (not shown).
- Fill the cooling system with coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant - Change".
- Ensure that all electrical power for the jacket water heater is turned to the ON position.
Caterpillar Information System:
R250 Automatic Voltage Regulator Constant Volts Per Hertz Operation - Using Knee Frequency Control
2008/11/01 A New Outer Valve Spring Is Now Used {1100, 1108}
2008/12/08 A New Outer Valve Spring is Now Used {1100, 1108}
2008/11/17 A New Outer Valve Spring Is Now Used {1100, 1108}
120K Motor Grader Hydraulic System Oil Level - Check
2008/12/22 A New Turbocharger Cartridge is Used {1052, 1053}
C18 Fire Pump Industrial Engine Heat Exchanger - Assemble
120K Motor Grader Backup Alarm
3500 Generator Sets Safety Messages
3512, 3508 and 3516 Generator Sets Safety Messages
3612 and 3616 Engines Piston and Rings - Three Ring Piston
2008/10/27 Replace the Two-Piece Piston if the Piston Contacts a Valve {1225}
TH55FT-E70 and TH55FT-E90 Transmissions General Hazard Information
Installation Procedure for the Space Heater On Generator Sets{4450} Installation Procedure for the Space Heater On Generator Sets{4450}
3512B HD SR500 Generator Sets Configuration Parameters
Installation and Adjustment Procedure for the 332-8662 Actuator Kit (Wastegate){1052, 1053, 1057, 1940} Installation and Adjustment Procedure for the 332-8662 Actuator Kit (Wastegate){1052, 1053, 1057, 1940}
345D and 349D Excavators C13 Engine Supplement Radiator and Hydraulic Oil Cooler - Remove
345D and 349D Excavators C13 Engine Supplement Radiator and Hydraulic Oil Cooler - Install
3508, 3512, and 3516 Generator Sets Refill Capacities and Recommendations
TH55FT-E70 and TH55FT-E90 Transmissions Transmission Warm-up
345D and 349D Excavators C13 Engine Supplement Fan - Install
2008/11/10 New Starter Lines Group and Prelube Pump Group Are Used {1319, 1451}
345D and 349D Excavators C13 Engine Supplement Fan Drive - Remove
345D and 349D Excavators C13 Engine Supplement Fan Drive - Install