Atmospheric Pressure Sensor - Remove and Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Disconnect harness assembly (1) from atmospheric pressure sensor (2).
- Remove atmospheric pressure sensor (2) and the O-ring seal.
Show/hide table
Illustration 1 | g01437326 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install the O-ring seal onto atmospheric pressure sensor (2).
- Install atmospheric pressure sensor (2) and the O-ring seal. Tighten atmospheric pressure sensor (2) to a torque of
10 ± 2 N·m (88 ± 18 lb in) . - Connect harness assembly (1) to atmospheric pressure sensor (2).
Show/hide table
Illustration 2 | g01437326 |
Note: Check the O-ring seal for wear or for damage. If necessary, replace the O-ring seal.
Caterpillar Information System:
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0268 - FMI 02
C13 and C15 On-highway Engines Engine Monitoring System
C175-16 Locomotive Engine Water Pump
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0190 - FMI 03
G3500 A3 Engines Exhaust Temperature Module
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Hydraulic Control - Assemble
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Hydraulic Control - Disassemble
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Hydraulic Control - Install
TH55-E70 and TH55-E90 Petroleum Transmissions Transmission Hydraulic Control - Remove
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0190 - FMI 02
2007/12/01 Procedure to Use the Correct Mounting Bolts with the 10R-2356 Flywheel As {1156}
2007/12/24 Procedure to Use the Correct Mounting Bolts with the 10R-2356 Flywheel As {1156}
C27 and C32 Engines for Caterpillar Built Machines Electronic Service Tool Does Not Communicate
C9 Petroleum Engines Coolant Temperature Sensor - Remove and Install
C9 Petroleum Engines Engine Oil Pressure Sensor - Remove and Install
3176C, 3406E and 3456 Industrial Engines Electrical Connectors
2007/12/17 The Caterpillar Digital Voltage Regulator (CDVR) Has been Improved {4467}
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0269 - FMI 04
C9 Petroleum Engines Fuel Pressure Sensor - Remove and Install
C13 and C15 On-highway Engines Solenoid Valve - Test
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0333 - FMI 03
C9 Petroleum Engines Injection Actuation Pressure Sensor - Remove and Install
Electronic Modular Control Panel II+ Paralleling (EMCP II+P) GSC CID 0333 - FMI 04
C9 Petroleum Engines Speed/Timing Sensor - Remove and Install