Engine Oil Filter - Duplex
Show/hide table
Illustration 1 | g01421468 |
Front view |
(1) Lubricate the bore of the five O-ring seals lightly with clean engine oil.
(2) Torque for the three bolts ...
(3) 2W-1635 Spring
- Length under test force ...
102.0 mm (4.02 inch) - Test force ...
518 ± 26 N (116.5 ± 5.8 lb) - Free length after test ...
143.4 mm (5.65 inch) - Outside diameter ...
37.251 mm (1.4666 inch) - Test force ...
Note: The bypass valve (4) must move freely in the bore.
(4) Bypass valve
- Start to open pressure ...
287 ± 7 kPa (41.5 ± 1.0 psi) - Fully open pressure ...
480 ± 7 kPa (69.5 ± 1.0 psi) - Fully open pressure ...
For the procedure to adjust the duplex filter's toggle valve assembly, refer to Testing and Adjusting, "Duplex Oil Filter - Adjust".
Show/hide table
Illustration 2 | g01458733 |
(5) Fluid control valve group |
(6) Before assembly, lubricate the bore of the two O-ring seals with clean engine oil.
(7) Torque for the nut ...
(8) Torque for the retainer nut ...
Caterpillar Information System:
320D and 323D Excavators Machine System Specifications Joystick Control
C9 Petroleum Engines Water Temperature Regulator - Remove and Install
C15 and C18 Petroleum Generator Sets Plate Locations and Film Locations
C18 Petroleum Generator Sets Plate Locations and Film Locations
C9 Petroleum Engines Water Pump - Install
2007/11/19 The Air Filter Element Assembly is Updated {1051, 1054}
3406C Marine Auxiliary Generator Set Zinc Rods - Inspect/Replace
C9 Petroleum Engines Water Pump - Remove
797F Off-Highway Truck Power Train Relief Valve (Transmission Main) - Install
797F Off-Highway Truck Power Train Relief Valve (Transmission Main) - Remove
C15 and C18 Petroleum Generator Sets Product Lifting
C9 Petroleum Engines Engine Oil Pump - Install
C3.3 Industrial Engine Safety Messages
2007/11/19 Improvements Made To Connectors For The EMCP3 Control Panel {4490}
C15 and C18 Petroleum Generator Sets Product Description
2008/01/28 A New Floating Aftercooler Core is Now Used {1063, 1380, 3319}
325D and 329D Excavators and 325D Material Handler Machine System Specifications Joystick Control
3176C, 3406E and 3456 Industrial Engines Throttle Position Sensor - Calibrate
3176C, 3406E and 3456 Industrial Engines Timing - Calibrate
345B Series II Excavator Machine System Specifications Travel Motor
G3520C and G3520E Engines Air Lines - Compressor Bypass
C9 Industrial Engines Exhaust Manifold
C15 and C18 Petroleum Generator Sets Fuel System - Prime
C18 Petroleum Generator Sets Fuel System - Prime