Engine Oil Pump - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0510 | Driver Gp | 1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install shaft (9) onto engine oil pump (1). Use Tooling (A) and a suitable press in order to install bearing (10) into idler gear (11). Install the bearing so the distance between the hub bolt face of idler gear (11) and the bearing is
0.75 ± 0.25 mm (0.030 ± 0.010 inch) . Position idler gear (11) on shaft (9). Install the washer and bolt (12).Show/hide tableIllustration 2 g01172397 - Inspect the condition of the gasket. Replace the gasket, if necessary. Position the gasket and oil pickup tube (6). Install bolts (5).
- Inspect the condition of the O-ring seal. Replace the O-ring seal, if necessary. Position the O-ring seal and outlet elbow (8). Install bolts (7).
Show/hide table
Illustration 3 g01172390 Note: Ensure that the mounting surfaces for the engine oil pump are thoroughly clean.
- Inspect the condition of the O-ring seal. Replace the O-ring seal, if necessary. Install the O-ring seal that is located between the cylinder block and the outlet elbow. Position engine oil pump (1) on the cylinder block.
- Install bolts (2).
- Install bolt (3).
- Install bolts (4).
Show/hide table
Illustration 1 | g01172401 |
End By:
- Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
C32 Petroleum Generator Sets Fuel System - Prime
C9 Petroleum Engines Engine Oil Pump - Remove
C13 and C15 On-highway Engines Air System Verification Test
G3500B Engines Vibration Damper Guard
G3500 Engines Vibration Damper Guard
2008/08/01 An Improved Stud Is Now Used on High Pressure Turbochargers {1059}
797F Off-Highway Truck Power Train Relief Valve (Transmission Lubrication) - Install
797F Off-Highway Truck Power Train Relief Valve (Transmission Lubrication) - Remove
C9 Petroleum Engines Engine Oil Pump - Assemble
797F Off-Highway Truck Power Train Modulating Valve (Transmission Clutch Engaging) - Assemble
320D Excavator System Pressure Release
C9 Petroleum Engines Engine Oil Pump - Disassemble
C15 and C18 Petroleum Generator Sets Product Lifting
797F Off-Highway Truck Power Train Relief Valve (Transmission Main) - Remove
797F Off-Highway Truck Power Train Relief Valve (Transmission Main) - Install
C9 Petroleum Engines Water Pump - Remove
3406C Marine Auxiliary Generator Set Zinc Rods - Inspect/Replace
2007/11/19 The Air Filter Element Assembly is Updated {1051, 1054}
C9 Petroleum Engines Water Pump - Install
C18 Petroleum Generator Sets Plate Locations and Film Locations
C15 and C18 Petroleum Generator Sets Plate Locations and Film Locations
C9 Petroleum Engines Water Temperature Regulator - Remove and Install
320D and 323D Excavators Machine System Specifications Joystick Control
G3500B Engines Engine Oil Filter - Duplex