Governor Drive - Disassemble - Later
Disassembly Procedure
Start By:
- Remove the governor drive. Refer to Disassembly and Assembly, "Governor Drive - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (4). Remove thrust washer (3). Remove shaft assembly (8) from housing assembly (1) .
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00627413 |
- Remove bolts (6). Remove thrust washer (5). Remove pinion (9) from housing assembly (1). Remove coupling (7) .
Note: If removal is necessary, remove gear (2) from shaft assembly (8) .
Note: If removal is necessary, remove the bearings from housing assembly (1). Replace the old bearings with new bearings. When the pinion bearing is being installed, press the bearing until the bearing is flush with the top of the counterbore.
Caterpillar Information System:
3608 Engine Governor Drive - Disassemble - Earlier
3608 Engine Fuel Pressure Control Valve - Disassemble
3608 Engine Fuel Pressure Control Valve - Remove
3608 Engine Fuel Transfer Pump - Remove
2008/01/01 Use the Correct Fittings for the Fuel Manifold {1274, 1380}
3608 Engine Auxiliary Water Pump - Disassemble
3608 Engine Auxiliary Water Pump - Remove
3608 Engine Water Pump - Disassemble
3608 Engine Air Starting Motor - Remove
3176C, 3406E and 3456 Industrial Engines Electrical Power Supply - Test
2008/12/08 Procedure for Cleaning the Power Train {3065, 3139}
3608 Engine Valve Lifter - Install
3608 Engine Engine Oil Pump - Remove
C7 Petroleum Engine Safety Messages
3608 Engine Priority Valve - Remove
3608 Engine Priority Valve - Disassemble
C15 and C18 Petroleum Engines Fuel Priming Pump
C15 and C18 Petroleum Engines Fuel Priming Pump
C15 and C18 Petroleum Engines Fuel Priming Pump
C9 Petroleum Engine Safety Messages
311D, 312D, 312D2, 313D, 313D2, 314D, 315D, 318D, 318D2 and 319D Excavators Machine Electronic Control System MID 039 - CID 0167 - FMI 12
G3500 Engines Engine Oil Lines
G3520C and G3520E Engines Engine Oil Temperature Regulator
3608 Engine Vibration Damper - Install