Valve Mechanism - Remove
Removal Procedure
Start By:
- Remove the valve cover. Refer to Disassembly and Assembly, "Valve Cover Base - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) that hold rocker arm assembly (2). Remove rocker arm assembly (2). Use a paint stick to place identification marks on the rocker arm assembly so that the rocker arm assembly can be installed in the same location.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00670986 |
- Use a paint stick to place identification marks on pushrods (4) for assembly purposes and remove pushrods (4) .
Show/hide table
Illustration 2 | g00638228 |
- Remove valve bridges (3). Identify the location of each valve bridge so that the valve bridges can be installed in the same location.
- Inspect the bore of each valve bridge for roughness or wear. Be sure that the passage for lubrication in the valve bridge is not restricted.
- Inspect bridge dowels (5) for roughness or wear. If removal of the bridge dowel is necessary, refer to Disassembly and Assembly, "Cylinder Head - Disassemble".
Caterpillar Information System:
3608 Engine Cylinder Head - Assemble
3608 Engine Cylinder Head - Disassemble
3608 Engine Flywheel and Ring Gear - Remove and Install
EMCP3 Charge-Fail False Alarm At High Temperatures and Low Temperatures{4490} EMCP3 Charge-Fail False Alarm At High Temperatures and Low Temperatures{4490}
G3520C and G3520E Engines Engine Oil Pan
2007/10/08 Improved Reliability of the Crankshaft Flange {1157}
C9 Petroleum Engines Jacket Water Heater
C18 Petroleum Generator Sets Maintenance Interval Schedule - Standby
C18 Petroleum Generator Sets Maintenance Interval Schedule - Prime Power
Using the Caterpillar Electronic Technician (ET) Data Log{0785, 7610} Using the Caterpillar Electronic Technician (ET) Data Log{0785, 7610}
Check for the Correctly Wired 226-3423 Control Panel Gp (Alarm Panel, Key Switch){4490, 7451} Check for the Correctly Wired 226-3423 Control Panel Gp (Alarm Panel, Key Switch){4490, 7451}
C15 and C18 Petrolem Generator Set Engines Event Codes
3608 Engine Valve Lifter - Disassemble
C3.3 Industrial Engine Fuel Injection Lines
C3.3 Industrial Engine Fuel Injection Pump
C3.3 Industrial Engine Crankshaft - Steel Crankshaft
C3.3 Industrial Engine Crankshaft Pulley
C3.3 Industrial Engine Alternator
2008/10/06 A New Wire Harness for Marine Transmissions is Now Available {1408, 3030}
C3.3 Industrial Engine Turbocharger
C3.3 Industrial Engine Rocker Shaft
3608 Engine Cylinder Liner - Remove
C3.3 Industrial Engine Camshaft
C3.3 Industrial Engine Gear Group (Front)