Pivot Shaft - Remove and Install
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 196-8520 | Forcing Bolts | 2 |
B | - | LOCTITE C5-A | - |
Start By:
- Remove the track roller frame.
- Attach a suitable lifting device to pivot shaft (2). The weight of pivot shaft (2) is approximately
87 kg (191 lb) . Remove bolts (1). Use Tooling (A) to remove pivot shaft (2). Remove pivot shaft (2).Show/hide tableIllustration 3 g03742024 - Remove ring (3) from pivot shaft (2).
Show/hide table
Illustration 1 | g01878479 |
Show/hide table
Illustration 2 | g01878482 |
- Install pivot shaft (2) in the reverse order of removal.
- Raise the temperature of ring (3). Install ring (3) chamfer side out to Dimension (X). Dimension (X) is
365.5 mm (14.4 inch) . - Apply Tooling (B) to the flange of pivot shaft (2) prior to installation.
- Tighten bolts (1) to a torque of
1800 ± 200 N·m (1330 ± 150 lb ft) .
Show/hide tableIllustration 4 g01879523 - Raise the temperature of ring (3). Install ring (3) chamfer side out to Dimension (X). Dimension (X) is
Caterpillar Information System:
312F GC and 313F GC Excavators Machine Systems Boom Drift Reduction Valve
D7E Track-Type Tractor Power Train Track Roller Frame - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Coolant Contains Fuel
C27 and C32 Engines for Caterpillar Built Machines Coolant Contains Oil
C27 and C32 Engines for Caterpillar Built Machines Alternator Problem - Charging Problem and/or Noisy Operation
926M, 930M and 938M Wheel Loaders Machine Systems Lift Cylinder - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Sensor Signal (Analog, Passive) - Test
C27 and C32 Engine for MD6250 and MD6310 Drill Timing - Calibrate
C27 and C32 Engines for Caterpillar Built Machines Sensor Signal (Analog, Active) - Test
C280 Marine Engines DEF Pump Motor - Test
D7E Track-Type Tractor Systems ROPS Group
D7E Track-Type Tractor Systems Sprocket Segment
C27 and C32 Engines for Caterpillar Built Machines Crankcase Pressure Is High
2014/11/26 New Separate Circuit Vent Lines Check Valve Is Now Available on Certain D7E Track-Type Tractors {1377, 1380}
834K Wheel Dozer Diesel Exhaust Fluid Filter - Replace - Emission Related Component
C27 and C32 Engines for Caterpillar Built Machines Cylinder Is Noisy
C27 and C32 Engines for Caterpillar Built Machines Engine Cranks but Does Not Start
335F Excavator Engine Oil and Filter - Change
335F Excavator Engine Oil Sample - Obtain
335F Excavator Safety Messages
D7E Track-Type Tractor Systems Equalizer Bar
D7E Track-Type Tractor Systems Oil Filter (Power Train)
D7E Track-Type Tractor Systems Angling Bulldozer
D7E Track-Type Tractor Systems Hydraulic Tank and Filter