Diesel Particulate Filter
Show/hide table
Illustration 1 | g01519534 |
Typical example |
Note: Degree of orientation for two clamps (1) and two straps (3) within the zone (C) is 70 degrees.
(1) Torque for two clamps ...
(2) Apply 4C-5599 Anti-Seize Compound to the bottom three threads of the temperature probe.
(3) Torque for two straps ...
Note: Degree of orientation for two straps (4) within the zone (D) is 60 degrees.
(4) Torque for two straps ...
Caterpillar Information System:
C13 Engine Flywheel Housing - Remove and Install
CX28 On-Highway Transmission Transmission Control
CX28 On-Highway Transmission Speed Sensor (Transmission)
C18 Marine Engines Sensor Signal (PWM) - Test
C18 Power Module Single Unit Operation
Updating Wiring and Harnesses for the Exhaust Combustion Groups on Heavy-Duty Engines{1408, 1722} Updating Wiring and Harnesses for the Exhaust Combustion Groups on Heavy-Duty Engines{1408, 1722}
C18 Power Module Voltage Regulators
3524B and C175 Engines for Off-Highway Truck/Tractors Auxiliary Water Pump
C32 Marine Engine Engine Oil Level Gauge - Calibrate
2007/10/01 New Software is Now Used on Marine Engines {1901, 1902, 7620}
2007/04/23 A New Fan is Used {1356, 1360}
C18 Marine Engines Speed Control (Switch) - Test
C13 Engine Valve Mechanism Cover Base - Remove and Install
C15 On-Highway Engine Diesel Particulate Filter
Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214} Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214}
2007/05/21 An Update for Calibrating the Engine Oil Level Gauge {1326}
C3.3 and C4.4 Rental Generator Sets Starting the Engine
Torque on the Impeller Bolt on Remanufactured Water Pumps{1361} Torque on the Impeller Bolt on Remanufactured Water Pumps{1361}
C18 Marine Engines Fuel Level - Test
C13 Engine Camshaft - Remove
C13 Engine Camshaft - Install
C13 Engine Engine Oil Pan - Remove and Install
C3.3 and C4.4 Rental Generator Sets Control Panel
C3.4 IND Industrial Engine Plate Locations and Film Locations