Flywheel Housing - Remove and Install
Removal Procedure
Start By:
- Remove the rear crankshaft seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolt (2) .
Show/hide table
Illustration 1 | g01371691 |
- Remove studs (1) and remove plate (3) .
- Remove bolts (4) and remove flywheel housing (5) .
Show/hide table
Illustration 2 | g01371697 |
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Position the O-ring seal and install flywheel housing (5). Install bolts (4) .
Show/hide table
Illustration 3 | g01371697 |
- Position plate (3) and install studs (1) .
Show/hide table
Illustration 4 | g01371703 |
- Install bolt (2) .
End By: Install the rear crankshaft seal. Refer to Disassembly and Assembly, "Crankshaft Rear Seal - Install".
Caterpillar Information System:
CX28 On-Highway Transmission Transmission Control
CX28 On-Highway Transmission Speed Sensor (Transmission)
C18 Marine Engines Sensor Signal (PWM) - Test
C18 Power Module Single Unit Operation
Updating Wiring and Harnesses for the Exhaust Combustion Groups on Heavy-Duty Engines{1408, 1722} Updating Wiring and Harnesses for the Exhaust Combustion Groups on Heavy-Duty Engines{1408, 1722}
C18 Power Module Voltage Regulators
3524B and C175 Engines for Off-Highway Truck/Tractors Auxiliary Water Pump
C32 Marine Engine Engine Oil Level Gauge - Calibrate
2007/10/01 New Software is Now Used on Marine Engines {1901, 1902, 7620}
2007/04/23 A New Fan is Used {1356, 1360}
C18 Marine Engines Speed Control (Switch) - Test
C9.3 Tier 4 Final Engines Engine Valve Lash - Inspect/Adjust
C13 On-highway Engine Diesel Particulate Filter
C13 Engine Valve Mechanism Cover Base - Remove and Install
C15 On-Highway Engine Diesel Particulate Filter
Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214} Inspection Procedures and Specifications for Pistons and Piston Pins {1214, 1214}
2007/05/21 An Update for Calibrating the Engine Oil Level Gauge {1326}
C3.3 and C4.4 Rental Generator Sets Starting the Engine
Torque on the Impeller Bolt on Remanufactured Water Pumps{1361} Torque on the Impeller Bolt on Remanufactured Water Pumps{1361}
C18 Marine Engines Fuel Level - Test
C13 Engine Camshaft - Remove
C13 Engine Camshaft - Install
C13 Engine Engine Oil Pan - Remove and Install
C3.3 and C4.4 Rental Generator Sets Control Panel